Electronics Forum | Tue Jun 16 23:05:51 EDT 1998 | Ben Salisbury
| Ben: Why not consider some of the training suggestions made by SMTNeter's to Marcos on the tread shown below? Dave F | Looking for Training in SMT process - Marcos Silva 15:24:13 6/12/98 (7) Dave- I did happen to look over those posts before writ
Electronics Forum | Wed Jun 17 08:28:59 EDT 1998 | Dave F
| | Ben: Why not consider some of the training suggestions made by SMTNeter's to Marcos on the tread shown below? Dave F | | Looking for Training in SMT process - Marcos Silva 15:24:13 6/12/98 (7) | Dave- I did happen to look over those posts befor
Electronics Forum | Wed Jun 17 17:56:44 EDT 1998 | Ben again
| Ben: NEPCON does not have to cost $20k, try $3K. Dave F | Airfare for advance ticketing $200 | Room ($60*4 nights ) 240 | Chow ($50*4 days) 200 | Learning courses ($800*3 courses) 2,400 | TTOTAL
Electronics Forum | Wed Jun 17 18:04:42 EDT 1998 | Dave F
| | Ben: NEPCON does not have to cost $20k, try $3K. Dave F | | Airfare for advance ticketing $200 | | Room ($60*4 nights ) 240 | | Chow ($50*4 days) 200 | | Learning courses ($800*3 courses) 2,400 | | TTOTAL
Electronics Forum | Wed Jun 17 20:03:54 EDT 1998 | Ben...heh...bet your gettin sick of this
Let's try this: | Here in Pennsylvania, the state legislature subsidizes training that employers provide. So here, the employer pays half and the state pays half. Is there a similar program out in Washington? | Dave F Well, we kind of do, it's call
Electronics Forum | Wed Jul 12 09:45:16 EDT 2000 | Charlie
The following are questions my boss has ask me to send out to you folks. This is done in an effort to see "What does the rest of the world do?" [if such a world could possibly exists, in the first place]. If you would select any or all questions to r
Electronics Forum | Thu Jul 13 05:23:30 EDT 2000 | Donnie
There a few questions that I have for you. 1. What type of flux are you using? 2. What temps are your preheaters set at? 3. Can you possibly place them on after the wave? The reason I'm asking is that there may be some adjustments to the wave to bur
Electronics Forum | Thu Jul 13 10:10:48 EDT 2000 | Todd
Donnie In response to your questions; 1. Flux is Multi-core X32-10M 2. Preheaters temperatures can range based on board density. the goal is to get the top side to 100C before wave. 3. Components can't be placed after wave solder, they are surface m
Electronics Forum | Thu Jul 23 22:50:38 EDT 1998 | Steve Gregory
Hey youse guyz... We're finally getting our first real job at the start-up I'm working at. It's actually a pretty unique little board too. Simple as all get out, but unique. You're not gonna believe what this goes into...guess? (I bet ya' you'll neve
Electronics Forum | Thu May 15 03:14:33 EDT 2003 | Hon Choi
Dear all, Not sure if you have this experience, but we've been seeing shorts on the BGA's from a widely known supplier "i". These shorts can not be found on the X-Ray, and when we remove the BGA, the component is ok. We peeled a few BGA's off, and
