Electronics Forum | Wed Apr 18 09:16:51 EDT 2007 | Cecil
We currently have an assembly that we have to mask the surface of several (24)SMT components where thermal compound is applied at a latter operation. These component packages vary from BGA's to QFP's. After the thermal compound is applied the PWA is
Electronics Forum | Fri Oct 08 09:43:27 EDT 2004 | davef
First, don't get too excited about the thermal capabilities of conductive epoxy. An epoxy like DuPont CB-100 increases the amount of heat conducted through the barrel, but many over estimate what it can do. Calculations show for a 0.020" drilled
Electronics Forum | Mon Feb 05 10:21:21 EST 2007 | davef
Thermal conductivity [W/m-�C] * Silver: 418 * Aluminum: 403 * Copper [rolled annealed]: 392 * Copper [electrodeposited]: 392 * Gold: 297 * Nickel: 90.7 * Tin: 73 * SAC: 73 * Castin: 57 * Pb37Sn63: 51 * Lead: 35 * Epoxy, phenolic: 25-75 * Conformal co
Electronics Forum | Wed Feb 26 04:28:39 EST 2014 | chongns
Hi All member I have a problem on the stable down the color of the white solder mask PCB. first, i tough the color differences was cause by the solder mask ink, but after a close look, the color change are cause by the copper under the solder mask
Electronics Forum | Thu Jun 04 08:32:21 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Wed Jun 03 21:25:33 EDT 1998 | John Allan
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Wed Aug 09 22:11:46 EDT 2000 | Dave F
Mark: The best routing of test vias for BGAs is to keep them far away from the device. We route test pads for the outer two rows of balls and use vias as test pads for the inner rows of balls. Your bottom-side layout is fine. Yes, on the top-side
Electronics Forum | Thu Jun 04 12:22:12 EDT 1998 | John Allan
| | | Hello: | | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold jo
Electronics Forum | Mon Jun 07 10:57:31 EDT 1999 | Dave F
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
Electronics Forum | Tue Jun 29 04:45:10 EDT 1999 | Earl Moon
| | Hey there gang, how's it going ? | | | | Anyway's here's my probelm, got a new product to build double sided reflow, lot's of so20's and PLcc's 1206's, 0805's the usual stuff. Probelm is all the pad spacing of the 1206's are too big, my componen
.jpg)
