Electronics Forum | Tue Feb 26 05:10:17 EST 2008 | adetuc
Thanks for the reply Hege, I calibrate the machines every 3 months and have checked that the board carrier to nozzle parralelism is ok. Have tried many different profile settings using a MOLE for readings but still collapsing on one corner. I did
Electronics Forum | Wed Oct 24 11:14:44 EDT 2001 | Cemal Basaran
Dave; Thanks for responsding so fast. here are my answers. 1-WOW!!! How do people get these cool toys? I am with the University at Buffalo Electronic Packaging Lab. http://www.packaging.buffalo.edu We have pretty much everything that is sold on the
Electronics Forum | Thu Dec 15 12:10:07 EST 2005 | muse95
It should be the other way around. A Pb BGA ball will fully melt in a Pb free process, but a Pb free BGA ball will not fully melt in a Pb process, which means the Pb from the paste on the board will not fully diffuse through the ball. This leads to
Electronics Forum | Wed Oct 24 18:08:02 EDT 2001 | davef
1- DF1: WOW!!! How do people get these cool toys? CB: I am with the University at Buffalo Electronic Packaging Lab. http://www.packaging.buffalo.edu We have pretty much everything that is sold on the market as well as Laser inspection technologies we
Electronics Forum | Fri Dec 16 08:00:26 EST 2005 | jax
What you are most likely dealing with: Insufficient Pure Sn layer ( multiple causes ) Because elevated temperatures accelerate the diffusion process, the thickness of the Pure Sn layer will reduce during every thermal cycle... ( bakeing PCBs, S
Electronics Forum | Fri Sep 03 16:43:13 EDT 2021 | djenkins62
Hello Everyone, We are building devices to remove moisture from boards prior to rework where it does not require the use of ovens as stated in IPC-TM-650, Method 2.6.28. Instead of evaporation, we use moisture magnets to pull out the part......even
Electronics Forum | Thu May 07 20:28:35 EDT 2009 | davef
From our notes, the following is a series of snips from: "Copper Dissolution in Tin" LJ Turbini, PhD, adjunct faculty member, University of Toronto, Materials Science and Engineering, SMT 2/07 As the solder becomes molten, copper from the board diff
Electronics Forum | Mon Nov 25 09:06:15 EST 2002 | jax
You might want to check the tin thickness. I believe you have a minimum of .65 microns in order to achieve a good solder joint through 3 thermal passes. In an immersion tin process, the ability to solder is time and temperature dependant. As the int
Electronics Forum | Fri Nov 02 09:09:56 EDT 2012 | davef
Sure you can use it it with leaded HASL. Recognize that ... * Your Sn42/Bi58 will no linger be Sn42/Bi58 * Your leaded HASL will no longer be the same leaded HASL that walked in the door to your plant * Lead from HASL coatings can diffuse through the
Electronics Forum | Wed Aug 14 18:19:09 EDT 2013 | jlawson
Generally the heller exl range has issues in cross profile, some machines more than others. I have see as bad as 15 deg c and as low as 5 deg c ranging from entire length to a few zones. They never match the specification in reality. The markiii is
