Electronics Forum | Tue Feb 01 04:11:58 EST 2000 | emmanuel
I am to assembly a power SO on the top side of a double side board. My designer has implemented a lot of thermal vias in the heat sink pad of this component. The problem is that i need to prevent the solder cream from polluting the bottom side of the
Electronics Forum | Sat Sep 14 01:34:19 EDT 2002 | Yngwie
I have the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcoming designs? 2) What are the manufacturi
Electronics Forum | Wed Feb 27 19:55:13 EST 2002 | nifhail
Hi, I need help to understand further on the via in pad for 0402 requirement. If I were to do the DFM over the brd design which consist of 0402 with via on pad, what is the criteria that I should look for ? I learned that the via in pad does not wor
Electronics Forum | Sat Oct 12 06:43:49 EDT 2002 | davef
Alternatives to consider are: * Opening-up your stencil aperture put-down more paste to compensate for the amount that is being used to fill the via. * Relaying-out the board to plug and plate over the via. * Relaying-out the board to move the via fr
Electronics Forum | Sat Mar 27 08:15:02 EST 2004 | davef
Via in pad is a designer's dream and an assembler's nightmare. Search the fine SMTnet Archives for previous discussions to get started. VIP, via-in-pad, or whatever tend to promote voiding within the via and certainly partially starved solder conne
Electronics Forum | Sat Oct 12 05:40:05 EDT 2002 | Kenture
Hello All, I am having issued with insufficient solder due to via in pad. It is a 10 mils via and PCB is 70 mil thick. Six mils stencils was used since there are some 20 mils (No clean process). Any recommendation? Thank you.
Electronics Forum | Fri Mar 16 17:15:51 EDT 2007 | davef
Ask the board fabricator to: * Fill the vias with resin. * Then metalize and copper plate the filled via along with the pad. * Then plate with solderability protection. This results in what appears to be a solid pad. For more, look here: http://www
Electronics Forum | Fri Mar 23 09:13:48 EDT 2007 | Peter W
Hello, those plated and solderable via in pads have two critical points: 1. We have discovered that _sometimes_ the plating seems not to be perfect, as extreme voiding is visible in tha bga solder ball 2. The detection of some defects by AXI is limi
Electronics Forum | Thu Mar 15 13:27:45 EDT 2007 | Pete
We had a customer do a similar thing. We notified our customer and educated them on what was happening. We were instructed to try one and report on the results, as the vias were supposed to be filled (and weren't). We pasted and reflowed and as su
Electronics Forum | Wed Mar 14 13:16:54 EDT 2007 | Shane
I have a customer that designed a fine pitch BGA into a board, and has put small vias in the middle of each pad on the PCB. Anyone have any ideas on how I can prevent the solder from the BGA from flowing through the vias and causing voids or no cont
