Electronics Forum | Fri May 18 15:58:37 EDT 2018 | mainenetservices
Please contact Heller at info@hellerindustries.com with oven model and serial number.
Electronics Forum | Fri Aug 10 09:24:10 EDT 2007 | babe7362000
I am seeing allot of issues with SOD-323's in our Heller Oven. The parts seem to move or blow off their pads. We do have all the fan speeds on low and still having this issue. The parts are sitting in the paste not on top, so there is some force o
Electronics Forum | Wed Aug 22 08:30:02 EDT 2007 | davef
Could there be a vibration on or jamming of the conveyor of your oven that is causing these parts to tip-over?
Electronics Forum | Wed Aug 22 09:59:06 EDT 2007 | slthomas
Are there long lags between print and place, and place and reflow? Could your paste be losing some of it's tack?
Electronics Forum | Wed Aug 22 22:07:53 EDT 2007 | mdm4ua
Easy fix is put a drop of washable mask on the side of part before reflow. The mask dries before the solder reflows and holds the part in place. After reflow it washes away.
Electronics Forum | Wed Aug 22 16:23:06 EDT 2007 | rgduval
I had the lurching issue...turned out I needed to readjust to cog wheels on the exit side of the oven. The cogs had slipped, and the chain was actually getting caught in the teeth...to the point that as the wheel turned, the chain would stay in it i
Electronics Forum | Wed Aug 22 14:28:56 EDT 2007 | russ
our biggest problems with these parts is them laying on their sides after placement with a certain machine that we have. make sure that you do not have a planarity issue as well menaing that the leads are indeed below the body of the component. I a
Electronics Forum | Wed Aug 22 16:11:15 EDT 2007 | razor1
If the problem appears to be random... we had a similar problem. We found that the belt which feeds the PCB through the reflow oven would jump or lurch ahead. It was barley noticeable but if you have identified the frequency and time of the compone
Electronics Forum | Fri Jul 01 10:54:25 EDT 2005 | vikkaraja
I had similar issue with our new 1809 Heller Oven recently. It was blowing off some of the lighter parts. I tried kitchen exhaust fan mesh screen (you can pick this up at your local hardware store). Once I knew it was air flow issue, I played with b
Electronics Forum | Wed Jun 29 17:56:47 EDT 2005 | Ryan
We have a new Heller 1809 EXL reflow oven and when we run MELF�s or Aluminum Electrolytic Capacitors through the oven they are being blown off the pads. I have verified that the placement is good before reflow. I verified that they are pushed down
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
winsouce.jpg)