Electronics Forum | Wed Sep 16 14:04:33 EDT 2015 | adventurelights
Hi guys, Recently got an error message when initiating hardware on a Mydata TP9-UFP. Message is: Theta/2: Lower end point not repeatable. Reinitiating fails at message. Haven't seen this message before. Any idea what it could be as production is hal
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Tue Apr 05 05:19:30 EDT 2005 | blueflag
Breakdown help machine will not 0 set upper end point limits on Z axis Theta / lower end point missed Thanks Colin
Electronics Forum | Fri Apr 22 14:28:38 EDT 2005 | Gary Goldberg - PROMATION
Low end selective laser soldering systems are limited to what types of soldering can be performed. I have read through the previous comments and find that most have commented on earlier technologies (which do not offer the features today's system do)
Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas
I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th
Electronics Forum | Tue Aug 07 21:17:24 EDT 2001 | davef
This provides LT 3 misses /1M hits. * Probe all points on one side of the board. Bonus => This lower fixture cost. * Test pads and vias: GT 25 thou from other land traces. * Small [LT 5 ohm] resistor measurements: Use two pads at each end and do 4-
Electronics Forum | Fri Jan 04 09:34:45 EST 2019 | ameenullakhan
Hi , thanks.. yes you are right.Its bot and top side. Decreasing the lower heaters and increasing the top heaters for secondary side. will this matter in convection reflow ovens. Since the heat at the end will get equally distributed. We were s
Electronics Forum | Sun Sep 09 02:24:04 EDT 2012 | audere
More lube on the O-Rings caused lots of problems. Nozzles would drop downward at times. So I pulled everything out and started from scratch. Testing 3 new Z-Rods, 4 used Z-Rods in good shape (replaced the O-Rings) and around 20 nozzles - the proces
Electronics Forum | Wed May 25 17:48:31 EDT 2011 | rssimmons
The SimmScope is an inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator to make the de
Electronics Forum | Thu Jan 24 09:53:56 EST 2002 | davef
You didn�t tell us about your solder, wave temperature profile, or the distribution of the problem. So, let�s assume the solder is near eutectic and the problem is wide spread. Wolfgang makes good points. So, let's talk a different tact. When we