Electronics Forum | Mon Jul 29 13:46:10 EDT 2002 | dbonilla
May you let me know a thick film house in the US or any other place?
Electronics Forum | Mon Jul 29 13:46:43 EDT 2002 | dbonilla
May you let me know a thick film house in the US or any other place?
Electronics Forum | Tue Jul 30 12:17:37 EDT 2002 | Jim M.
Aimtronics had done thick film hybrids for many a year. Please contact 613-592-2240 or E-mail myself at the following address, jmills@aimtronics.com Aimtronics is located in Ottawa, Canada which is just an hour away from our plant in Ogdenburg , New
Electronics Forum | Mon Jul 29 18:53:17 EDT 2002 | davef
For MCM, hybrid, thick film er whatever they call them nowa days: * Aimtronics [ http://www.aimtronics.com/micro_thickfilm.htm ] * ISSI [ http://www.internationalsensor.com/HYBRID_PAGE_HTML/HYBRID_PAGE.htm ] * Vetronix Research 1700 Harmon Rd Auburn
Electronics Forum | Tue Oct 24 22:36:29 EDT 2000 | DL
On the main page of Smtnet towards the end of the opening paragraph states the following...Your " research continues in determining the reliability of thick film hybrid microcircuits and similar technologies using low-temperature, co-fired ceramics.
Electronics Forum | Thu Oct 26 13:10:48 EDT 2000 | ptvianc
Yes, one should always be concerned about "field failures" because they represent the point at which the product has exceeded its design lifetime with respect to its service conditions. Hybrid microciruit technolgy (HMC) has been around for a long t
Electronics Forum | Mon Aug 07 18:20:40 EDT 2000 | Darby
James, I only use the clamshells for fine pitch if my other printers are non operational. Not reccommended but achievable in an emergency. In answer to your questions. We use two clam shell printers and two vertical lift printers. All are used for 8
Electronics Forum | Fri Sep 13 18:01:18 EDT 2002 | dbonilla
Do you know what will be the best solder process for pins at the edge of the ceramic substrate? Thanks
Electronics Forum | Fri Sep 13 18:01:39 EDT 2002 | dbonilla
Do you know what will be the best solder process for pins at the edge of the ceramic substrate? Thanks
Electronics Forum | Sun Sep 15 09:13:41 EDT 2002 | davef
A near eutechtic alloy [ie, 63/37, 62/36/2, etc] would be fine. People print, place, and reflow millions of cermaic capacitors with these alloys every day.
