Electronics Forum | Wed May 17 11:00:00 EDT 2000 | emmanuel
Has somebody yet process pcb (FR4) with a thickness of 0.8 mm ? Thank you for all kind of responses.
Electronics Forum | Thu Jun 09 07:02:02 EDT 2005 | ajaydoshi
1. We do have PCB with 0402 component, Micro BGA ( 0.5mm pitch , 0.25 mm pad size ). PCB thickness is 0.8mm. What stencil thickness we should use. PCB size 40 mm X 60 mm 2. We have EKRA E4 , What will be optimum setting for above. Pressure, Scquge s
Electronics Forum | Wed Oct 01 21:22:37 EDT 2003 | ramanandkini
We have a 1.6 mm thick automotive PCB board of size 35x70mm. One of our vendor has given us a batch with lesser soldermask thickness 5~8 microns. Will this affect the circuit board on a long term. What should be standard for the soldermask thickness?
Electronics Forum | Thu Jun 09 13:30:34 EDT 2005 | PWH
I would suggest 7mm thick "Durostone" as a carrier material. Cut lip/pocket for PCB so it is 0.05" thinner than thickness of PCB. Allow 0.010" gap on all sides of PCB. Machine lip to width between 0.050" and 0.100" to support under perimeter sides
Electronics Forum | Fri Feb 16 08:04:05 EST 2007 | GS
Hi, questions about PCB ImSn finishing : a) how much is the standard thickness (most common)? b) how much is the maximum thickness obtainable by this finishing process? Thank you Regards....GS
Electronics Forum | Mon Oct 06 12:37:18 EDT 2003 | ramanandkini
It was a nice discussion. What I did here was a thermal shock test 1 hour@ +90 deg.c and immediately 1 hour @ -40 deg.c. The second test I did was a high humudity test for a week. After each test, I carried out a peel test with scotch tape. Those bo
Electronics Forum | Thu Jun 09 07:36:49 EDT 2005 | ajaydoshi
Thanks, 1. Any idea how to go about pallet. because this PCB is single only ( not in multiple ). if you have some drawing / picture pl. send me at ajay_doshi@utlindia.com 2. What are other parameter to set on machine ajay
Electronics Forum | Tue Oct 07 02:18:13 EDT 2003 | iman
Hi Experts, Pls help advise what is the expected range of PCB gold thickness over Ni (for ENIG/Electrolytic fabrication processes)? any referrence standards set by the IPC?
Electronics Forum | Mon Aug 07 09:04:09 EDT 2006 | molos21
Hi everyone, I am starting to use the lead free process and I had a few wetting problems (solder did not reach top side) at the wave soldering process once the pcb had passed our smt line (one heat pass). From what I understand, I have had a problem
Electronics Forum | Wed May 17 11:56:00 EDT 2000 | John Thorup
We have one panel of 50 small boards that is 0.035" (0.89mm). Other than a dedicated fixture to support it during printing and placement we don't do anything differently. John Thorup
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
