Electronics Forum | Thu Jan 30 10:12:00 EST 2020 | emeto
More detail Jinesh. Profile, datasheet of the part, stencil design, PCB finish, soldering material. Initially I am assuming you use pallet to reflow 0.2mm thick board.
Electronics Forum | Thu Apr 15 05:17:51 EDT 1999 | Barry Aylett
Can anyone suggest or identifiy standards which tabulate the following: Conductor width, cross sectional and area conductor thickness for PCB's carrying up to 70 Amps?
Electronics Forum | Tue Aug 04 04:20:36 EDT 2020 | bangir
Hi Chris, It's arround +/- 2MM. There was a gap if running pcb with thickness 1MM. The PCB position below the rail table.
Electronics Forum | Tue May 14 11:52:04 EDT 2002 | Claude_Couture
Excuse me, but if I remember my physics lessons well, volume is what the water displacement measures, not mass. therefore, if you take the volume of water displaced by your populated PCB, divide it by the thickness of the PCB (which is easy to measur
Electronics Forum | Sun Sep 04 23:03:04 EDT 2005 | cabs
Thanks.... Can u direct me to a link or website of the companies that can perform this test???
Electronics Forum | Wed Sep 07 05:34:08 EDT 2005 | cabs
Thanks you so much for this information.... this will help a lot...
Electronics Forum | Tue May 28 18:57:40 EDT 2024 | lambert
The scoring or grooving creation is found in IPC-2222 and describes the standard scoring parameters, with an illustration of the critical parameters. There are many articles on the web describing the process. Many of the articles promote a groove dep
Electronics Forum | Wed Jul 24 09:54:49 EDT 2019 | amitthepcbguy
Typically, the reliability of PCBs suffers significantly due to the increase in aspect ratio. It is not preferred to opt for high thickness boards. However, I would like to point out that your assumption seems to be wrong as board layers do not direc
Electronics Forum | Tue Sep 07 21:15:20 EDT 2021 | dwl
This should be possible, but definitely get the OK from your customer first! Layer thickness may effect things like impedance, EMC, or other electrical properties of the assembly. out of curiosity, why do you want thicker boards?
Electronics Forum | Thu Oct 07 12:42:13 EDT 2021 | ervin
Hi I addition to the mentioned electrical effects, there are also reliabilty issues with increasing the board thickness, such as increased aspect ratio for the vias or registration difficulty
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
