Electronics Forum | Thu Jan 11 04:23:08 EST 2018 | jaisabaigroup
IPC-SM-840. > > If overall thickness is not > specified in purchasing documents, a supplier > will do whatever it wants. > > Specify your > requirements. Typical values are > 20-50um. > > Regards Thank you very much, Pavel.
Electronics Forum | Wed Jul 17 15:00:37 EDT 2013 | jmiller
what is the effect of pre-dip tank temp. and dip tank temp. on the thickness of the IAg?
Electronics Forum | Wed Apr 23 17:28:46 EDT 2008 | davef
The need to prebake boards to remove moisture from the board [to prevent voiding] prior to wave soldering is driven by the thickness of through hole plating. * 1 thou [25um] or greater requires no prebaking * LT 1 thou [25um] requires prebaking
Electronics Forum | Tue Oct 27 22:52:18 EDT 2009 | davef
Top picture: We're not wild about the 'poor registration,' the differing thickness of the solder mask, and the crud all over the board. But, then again, we don't have a basis for rejection. Bottom picture: No basis for rejection Help us out, what do
Electronics Forum | Sun Nov 01 23:51:44 EST 2009 | boardhouse
Hi Julie, My opinion is that the top board would not pass IPC, solder mask encroachment on pads. Second board is what we call Orange peel,this can be caused two way's. 1) the solder mask was not tack dried enough prior to imaging which caused artwo
Electronics Forum | Wed Jun 13 12:54:41 EDT 2001 | Dr. Harry
Does anyone have PCB thickness recomendations for .8 &1.0mm pitch bga's?
Electronics Forum | Thu Oct 07 20:34:48 EDT 1999 | Tony Huang
Hi, Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! Thanks, Tony
Electronics Forum | Fri Oct 08 17:12:31 EDT 1999 | Dave F
| Hi, | | Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! | | Thanks, | Tony | Hi Tony:
Electronics Forum | Tue Sep 02 09:32:45 EDT 2008 | eliezerk
In order to check pcb quality by HASL TIN thickness plating repeatability, looking for any specification for the above.
Electronics Forum | Thu May 28 07:25:58 EDT 1998 | Earl Moon
| Hey yooze guys! | Enough of the jokes between you and Earl (GRIN), let's get back to the topic...well, okay... you can tell a few more...(but good ones, 'kay?) | Anyhoo...I'm not sure if ya'll are on the IPC Technet list or not, I've not seen any p
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830