Electronics Forum | Fri May 29 07:17:30 EDT 2015 | kkay
We have a small board about 1" by .5" and it is .012" thick. It is in a 50 up panel. We have tried rat bites and v-score and we keep seeing delamination around the edges. Anyone have experience depaneling boards this thin?
Electronics Forum | Mon Jun 01 10:14:55 EDT 2015 | swag
Wow that's thin. We do lots of flex = similar thickness. We do most on a router but in a pinch we cut them out with a good pair of scissors.
Electronics Forum | Mon Jun 01 18:12:12 EDT 2015 | comatose
I've done V score that thin, but it takes some doing. Using a twin linear knife type machine. In quantity this seems like a perfect job for laser, though.
Electronics Forum | Mon Jun 01 11:01:46 EDT 2015 | tnisbet
Have to tried an automated system such as a Router or Press? tom@goppm.com Tom Nisbet
Electronics Forum | Mon Jun 01 12:02:03 EDT 2015 | kkay
They are too small to use on our router. Is there a way to cut boards with a press?
Electronics Forum | Tue Jun 02 09:32:24 EDT 2015 | tnisbet
Have to tried an automated system such as a > Router or Press? > > _a class=roll > href="mailto:tom@goppm.com"_tom@goppm.com_/a_ Tom > Nisbet .012 Is too thin for our Press & Die. How are you fixturing the panel on your router ? Do you have a d
Electronics Forum | Thu Jul 09 05:52:49 EDT 2015 | kfquan
Have you tried the so called push-back or re-insertion type panel? 5mm*12mm*0.3mm thick FR-4, 120-up panel is doable.
Electronics Forum | Wed Sep 22 08:26:53 EDT 1999 | g cronin
i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the screen/ass
Electronics Forum | Mon Jan 21 09:29:33 EST 2013 | cnotebaert
I agree, you will likely need a carrier being that thin. without seeing the trace layout I’m not sure about relieving the carrier to accommodate them. if evenly distributed you shouldn’t to go that far. Are parts on both sides of the board? Don’t mak
Electronics Forum | Mon Aug 16 04:31:15 EDT 2021 | bme57
Hi. I am looking for a printer that can print a conductive circuit on a thin film, like polyester or mylar film. Any lead would be appreciated. Thanks, bme
