Electronics Forum | Fri Aug 22 15:26:18 EDT 2008 | rway
I rarely use blk fiducials. But when I do, they are always programmed after the fids. It's the fids that sets your general alignment of the panel. I only use blk fidus for thin pcbs (30 mil) that tend to warp when on the conveyor.
Electronics Forum | Wed May 29 10:28:24 EDT 2019 | etmpalletguy
#1) Is the card in panel form: (Y)/(N) #2) PCB thickness: Thin card: YES, Thick card: See above. #3) is the PCB warping during reflow? (Y)/(N) #4) Is the PCB Symmetrical is shape & size? These are just some of the questions you need to ask yourse
Electronics Forum | Tue Apr 10 10:10:03 EDT 2001 | Rob Fischer
Obviously the less mass in the wave the better. There will be less heat sinking and less push on the solder. Pallet thickness is typically a function of the tallest component on the board. If the board has one component that is tall but small in a
Electronics Forum | Tue May 23 20:44:13 EDT 2000 | Dave F
Sal: You and Wolfgang are spot on, but let's see if we can blow this out a bit. Before proceding to rattle on ... � PC Card. A credit card-size computer peripheral that add memory, mass storage, and I/O capabilities to computers in a rugged, compa
Electronics Forum | Sun Mar 18 20:02:48 EDT 2018 | reckless
Thanks for your help every time! You are right table top units are a joke. For smaller conveyor ovens I found two major brands: Manix (no longer makes ovens) and Manncorp. The manncorp unit I am looking at does not have a bottom heat zone. Mos
Electronics Forum | Wed Jun 02 09:55:31 EDT 1999 | Jason Gregory
Hello Dan, I have recently started using polyimide, but not for the standard uses. I designed a pallet for holding small, thin (about .0018" thick) RF boards that were being reflowed inside their aluminum housings. They were screwed down to prevent w
Electronics Forum | Thu Jul 12 21:41:35 EDT 2001 | mugen
A) Questions: 1) What sort of pallet materials used? 2) what PCB thickness & LxW size? 3) what stencil type & thickness used? 4) what profile type used (peak deg-C)? 5) any peak Deg-C contraints for the components SMT onto the PCB? B) We use pallet
Electronics Forum | Thu Aug 10 13:12:10 EDT 2000 | Bob Willis
You may care to review the following from my Circuits Assembly page on line. "HOW FLAT IS FLAT AND DO WE NEED FLAT CIRCUIT BOARD, YES WE DO ? As production problems go there is one that keeps reoccurring time and time again. The blame is usually di
Electronics Forum | Mon Aug 17 02:50:44 EDT 1998 | Bob Willis
| Have an SRT w/preheat, 18 layer board all copper, 456 BGA needs to be removed and replaced. The manufacturer is Chip Express and during reflow it warps up or down. Causing either opens or shorts on the corners. I was using gel flux with multiple
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
| 1 |
winsouce.jpg)