Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Mon Sep 09 16:29:56 EDT 2013 | gregp
Hi Everyone, I'm looking for some feedback about through hole assembly requirements today vs. yesteryear. As I see it, there are two main categories...legacy through hole and new through hole with mixed technology. The legacy stuff is older designs
Electronics Forum | Tue Oct 01 15:48:56 EDT 2002 | lysik
No problem. A standard stencil is OK. You want to print a half moon shape on each side of the hole. Make sure you print about X2 the size of your hole and make sure you keep the print in close to the hole. You want to print X2 the hole size as to hav
Electronics Forum | Tue Oct 01 16:18:16 EDT 2002 | davef
Q1: Is this [paste in hole] feasible? A1: Yes, many people lower their operating cost by reflowing through hole components. Q2: What types of components are difficult to do this way [paste in hole]? A2: Types of through hole components that are d
Electronics Forum | Wed Sep 11 10:48:02 EDT 2013 | gregp
Hi Reese, The UIC machine is (was) good for higher volumes. Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts? Also, are the UIC through hole machines still fully supported with ampl
Electronics Forum | Fri Nov 21 10:28:23 EST 2014 | gregp
Hi Adam, So with two to three people on the slide line, each only able to place five different components maximum, this means you generally don't exceed 10-15 through hole parts per assembly, correct? I am guessing these are mixed technology boards
Electronics Forum | Mon Nov 17 13:43:39 EST 2014 | gregp
So we all know through hole assembly hasn't been completely eradicated. I am doing some research as to the types of through hole assembly that still remain. My questions are related to through hole requirements and past, current and future methodol
Electronics Forum | Tue Oct 01 12:23:26 EDT 2002 | barryg
We are looking at possible doing a few through hole components on the smt line. Is this feasable? What types of components are diffucult to do this way? What stencil considerations are there? Anyone have any info on this subject?
Electronics Forum | Wed Feb 07 11:27:25 EST 2007 | asoe
I just wonder anyone had the idea of solderability test for through hole by using a wetting balance equipment? I read the jstd002/003 however my feel is now our machine (metronelec st60) is not capable of this test?
winsouce.jpg)
