Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Sat Nov 08 09:42:22 EST 2003 | ethercom
Hi: I have seen this problem before. It is caused by improper curing of solder mask by the fab manufacturer. When you run the board thru' wave solder, and then wash the board, you see the problem of white residue. However, when you apply heat, you c
Electronics Forum | Wed Jul 23 03:04:57 EDT 2008 | gfro
Hello, We are using a PCB with thickness 3.2mm 4 layer and lot of through hole via's of diameter 0.4mm. We specified our PCB vendor to do plugging. Now we have big problems, that after 1..4 weeks we measure a low resistance between track's/via's of
Electronics Forum | Wed Dec 07 17:43:31 EST 2011 | mikenil
Hi I do not work for a board house but a manufacturing facility where we do a considerable amount of soldering wires to through holes. We pretin our through holes on both sides of the PCB prior to reflowing the solder and installing the conductor (w
Electronics Forum | Tue Feb 27 11:03:09 EST 2007 | Marcin
Hi All, Anybody knows what is the minimum clearance between through hole component and chip component? Problem description: On bottom side of my pcb are only 0603 chip components mounted on glue. One of the component is located very close to hole
Electronics Forum | Wed Jul 23 08:18:29 EDT 2008 | davef
Q1. Is this a standard process for plugging? A1. Not as such. We checked both IPC-6012 and IPC-SM-840. Neither comments on plugging. So, your fabrication notes rule the day. Q2. Is this okay for such thick PCB's or is it mandatory to use a special pl
Electronics Forum | Wed May 27 10:19:43 EDT 1998 | Jerry
We have no problems but orientation does matter. Orient with longest side of component body perpendicuar to wave. In other words the same preference as with through hole DIPS. Idea is the same as for through hole, that the surface tension will ten
Electronics Forum | Thu Aug 25 07:53:03 EDT 2016 | babe7362000
I was wondering how I would program the Mirtec MV-3L for through hole solder? Do I need to bring in the solder mask file? or can I do manually? Thanks
Electronics Forum | Thu Aug 25 16:14:34 EDT 2016 | jbuckley
group part, and at the top right of the program, you can change the name of the component and the name of the reference ID to whatever you'd like. I hope this helps.
Electronics Forum | Fri May 26 05:54:40 EDT 2000 | Sal
For the past year now we have been printing adhesive with no real problems. Our printing ranges from 0603's to SOIC using a variation of aperture sizes and metal thickness foils. The crucial parameters are : aperture sizes : These obviously depend o
.gif)
winsouce.jpg)