Electronics Forum | Fri Dec 09 11:00:47 EST 2011 | davef
Using common wire size and through hole diameter, we'd expect that the wave solder process would completely fill the through hole and that you wouldn't need to get involved in providing stencil openings, pasting the through hole or reflowing the jump
Electronics Forum | Wed Dec 07 17:43:31 EST 2011 | mikenil
Hi I do not work for a board house but a manufacturing facility where we do a considerable amount of soldering wires to through holes. We pretin our through holes on both sides of the PCB prior to reflowing the solder and installing the conductor (w
Electronics Forum | Wed Jul 23 03:04:57 EDT 2008 | gfro
Hello, We are using a PCB with thickness 3.2mm 4 layer and lot of through hole via's of diameter 0.4mm. We specified our PCB vendor to do plugging. Now we have big problems, that after 1..4 weeks we measure a low resistance between track's/via's of
Electronics Forum | Wed Jul 23 08:18:29 EDT 2008 | davef
Q1. Is this a standard process for plugging? A1. Not as such. We checked both IPC-6012 and IPC-SM-840. Neither comments on plugging. So, your fabrication notes rule the day. Q2. Is this okay for such thick PCB's or is it mandatory to use a special pl
Electronics Forum | Wed Jan 18 12:41:19 EST 2017 | emeto
Does anyone knows where I can buy these rubber cones? They work as masking - preventing the solder to adhere to through holes(rings) while wave soldering
Electronics Forum | Thu May 09 00:08:01 EDT 2002 | techment
Could someone provide help regarding IPC's recommendation on Plated Through hole's --- lead to hole ratio. I can't find it in IPC-2221 and IPC-SM-782. Thank you very much
Electronics Forum | Thu May 09 17:24:11 EDT 2002 | davef
First, SM-782 elates to surface mount pads. So, expecting to find PTH design rules there is a bit of a stretch. Search the fine SMTnet Archives for similar threads. For instance here�s one from last week: http://www.smtnet.com//forums/index.cfm?fu
Electronics Forum | Tue Jul 06 15:06:35 EDT 1999 | Mike Demos
Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area. This
Electronics Forum | Mon Mar 13 06:11:08 EST 2006 | Rob
Surely this is a job for Wavemaster Larry? Have you tried flux buster pins in your ICT yet? They are quite good at cutting through the crap on a board.
Electronics Forum | Tue Mar 07 08:48:55 EST 2006 | samir
Our ICT Guy here at my company loves to use lots of via holes as test points - via holes which are 0.040" diameter, and spaced at 0.004" edge to edge spacing! He doesn't like to tent the via's either, so I always battle via-to-via shorts at the wave