Electronics Forum | Tue Jul 27 04:18:55 EDT 2004 | Nippy
Hello, Is it possible to put polystyrene caps through the wave solder process ? We have always hand soldered these as temperature sensitive parts but would rather include them with other PTH parts through the wave solder. Manufacturer was little h
Electronics Forum | Tue Jul 27 09:44:48 EDT 2004 | davef
We hand solder them also. From CapSite 2004 ... "Whether polystyrene capacitors will really go away any time soon is not certain. I have been warned of polystyrene�s demise "in a few years" for over a decade now, and yet it is still available. The
Electronics Forum | Fri Oct 17 06:44:32 EDT 2014 | hemant_pang23
We are doing hand soldering for the 'BATTERY LITHIUM COIN CELL 3V CR 2032 but now we want do the soldering through wave soldering process ,for avoiding the shortckt only one pin will get solder through wave process and other pin will be soldered manu
Electronics Forum | Tue Sep 10 10:38:12 EDT 2013 | rway
Most of the PTH components are manually inserted. Some are auto-placed by our UIC machine. The parts are preped before install, so there is no need to trim the leads afterwards. The boards go through wave solder. The UIC machine has a clincher on
Electronics Forum | Sat Nov 08 09:42:22 EST 2003 | ethercom
Hi: I have seen this problem before. It is caused by improper curing of solder mask by the fab manufacturer. When you run the board thru' wave solder, and then wash the board, you see the problem of white residue. However, when you apply heat, you c
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Fri Oct 17 09:31:21 EDT 2014 | rgduval
To be honest, I have never had success wave soldering or reflow soldering batteries, regardless of their intended use. If you're going to continue a manual operation to solder one pin, I'd suggest that you just solder the entire component in by ha
Electronics Forum | Mon Apr 26 10:29:49 EDT 2010 | davef
Set pump speed so that the board is 1/3 to 1/2 immersed as it goes through the wave.
Electronics Forum | Mon May 10 20:23:43 EDT 2004 | wdlau
Hi, I am looking the practice when you are phasing in the LF wave soldering process of larger boards with Larger AL E- cap, are there any concerns about the heat resistant, is there any risk to damage the E cap as higher temp is a need for larger bd
Electronics Forum | Fri Nov 21 11:00:27 EST 2014 | gregp
Hi J_Dub (Joe), Thanks for the input. Sounds like some fairly densely populated through hole assemblies. 100 solder joints per board is up to 50 parts per board (I know you may have DIP's so it could be less than 50). 24 boards in a panel x 50 par
A global industrial auction and valuation business with extensive experience in SMT, PCB Assembly & Manufacturing, Test, Semiconductor and other Electronics Machinery & Equipment.
Manufacturer / Equipment Dealer / Broker / Auctions
896 Main Street
Branford, CT USA
Phone: 203-488-7020
winsouce.jpg)
.gif)
