Electronics Forum | Mon Sep 09 16:29:56 EDT 2013 | gregp
Hi Everyone, I'm looking for some feedback about through hole assembly requirements today vs. yesteryear. As I see it, there are two main categories...legacy through hole and new through hole with mixed technology. The legacy stuff is older designs
Electronics Forum | Fri Oct 12 13:40:56 EDT 2001 | Steve
I need help with a process issue. I am dealing with a board design that is double-sided SM with a couple high density through-hole devices. I want to flow solder the through-hole stuff, so what is the best way to deal with them? Since one of the thro
Electronics Forum | Thu Jul 27 10:45:12 EDT 2017 | georgetruitt
Does the Mirtec inspect the solder joints top/bottom of the through hole as well as the color value?
Electronics Forum | Fri Dec 09 11:00:47 EST 2011 | davef
Using common wire size and through hole diameter, we'd expect that the wave solder process would completely fill the through hole and that you wouldn't need to get involved in providing stencil openings, pasting the through hole or reflowing the jump
Electronics Forum | Wed Sep 13 15:54:53 EDT 2006 | Osvaldo Smith
Hello, I am trying to find some Programming and host manuals for the following Panasert and Sony machines: MSH-G1 (Panasert SMT) RH2 (Panasert Through Hole) RH3 (Panasert Through Hole) RH5 (Panasert Through Hole) JVK (Panasert Through Hole) AX (Pan
Electronics Forum | Tue Feb 27 11:03:09 EST 2007 | Marcin
Hi All, Anybody knows what is the minimum clearance between through hole component and chip component? Problem description: On bottom side of my pcb are only 0603 chip components mounted on glue. One of the component is located very close to hole
Electronics Forum | Tue Jul 06 15:06:35 EDT 1999 | Mike Demos
Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area. This
Electronics Forum | Wed Sep 11 10:48:02 EDT 2013 | gregp
Hi Reese, The UIC machine is (was) good for higher volumes. Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts? Also, are the UIC through hole machines still fully supported with ampl
Electronics Forum | Fri Nov 21 10:28:23 EST 2014 | gregp
Hi Adam, So with two to three people on the slide line, each only able to place five different components maximum, this means you generally don't exceed 10-15 through hole parts per assembly, correct? I am guessing these are mixed technology boards
Electronics Forum | Mon Jul 10 11:04:26 EDT 2017 | philc
We use a Mirtec MV-3L for SMT work, but now have a requirement for inspecting through hole boards. I am aware of many of the AOI machines for SMT work, but can't seem to find anything for through hole from a major (well-known) manufacturer. Any usef
