Electronics Forum | Sun Apr 19 11:19:52 EDT 2020 | davef
A-610G 7.5.16 Components with Bottom Thermal Plane Terminations (D-Pak) says: 100% wetting to land in the end-joint contact area. Is that what you're asking about? Regards, David Fish [davef] Technical Editor & Customer Advocate
Electronics Forum | Fri Nov 23 16:09:01 EST 2007 | davef
We're not real clear about what you're trying to discuss, because most capacitors are packaged in epoxy with a solderable termination on each end. But lets throw a couple of ideas at the wall and see what sticks. If this epoxy is: * From the capaci
Electronics Forum | Wed Mar 27 19:26:53 EST 2002 | ianchan
After a whole night's self review, I think we can term the slant/tilt as "floating 0805, yet end-terminals have acceptable solder joint formation". the width portion of the 0805 RES/CAP is (floating)elevated from the PCB pad, yet both (width) termin
Electronics Forum | Tue Feb 11 13:22:22 EST 2020 | rgduval
Sebas, I suspect that your finding of needing the fillet for the card to work is a false finding. One that I dealt with for many years in assembly. As a bottom terminated device, a fillet to the side terminals of the device is not required. Adequ
Electronics Forum | Tue Sep 24 11:10:07 EDT 2002 | Gregg Temkin
I�d appreciate assistance in trying to resolve a placement/soldering problem. My company has designed a board which uses a large number of 0402 LED�s that are .028� high. The LED�s need to be soldered so that they point straight up and are not til
Electronics Forum | Thu Jul 20 15:37:53 EDT 2000 | Tekguy2000
These parts are flat chip resistor arrays that have 4 end terminations on each side. It looks liek an IC but is typically in an 0805 and 1206 package type with convex terminations. .031" pitch from termination to termination and .011" spacing between
Electronics Forum | Tue Jan 30 12:16:47 EST 2007 | pbarton
We are seeing unusual soldered joints when soldering to components with Pt/Ag metallised terminations. At the margin between the bottom of the component termination and the PCB surface there are a number of blowholes in the bulk solder. There also ap
Electronics Forum | Tue Jul 19 10:28:21 EDT 2016 | mrk
What kind of oscillator are you placing (Manufacturer part #)? I do not believe that oscillators fall under the "chip component" category. Even if they did, most all SMT oscillators that I have come into contact with have 1 sided terminations on the
Electronics Forum | Tue May 12 10:03:12 EDT 2009 | daan_terstegge
Hi All, I see more and more components like QFN or LGA with bottom-only terminations,with landpatterns getting finer all the time. I have no ppm-figures of our process, but based on a benchmark study by Agilent I'd say that 500 ppm is a decent value
Electronics Forum | Mon Dec 02 16:25:06 EST 2002 | jimlew
In doing process qualifications for 0201 caps, has anyone taken cross-sections and discovered cracks / hairline fractures / voids between the metalization on the end and the ceramic itself? (not cracks in the solder joint) We are well within the cap
