Electronics Forum | Wed Dec 08 02:07:25 EST 1999 | Scott Cook
Tim, What Brian writes is all true. However, let em put it into a sales / marketing perspective..... The REAL issue in your situation is: Who is responsible for the failures which WILL result in shipping untested product? Typically, your customer
Electronics Forum | Wed May 12 17:37:08 EDT 1999 | Timothy O'Neill
| I am looking for anyone who has converted over to VOC Free flux. I need some info on any problems, etc. that you might have had. | | Please E-mail me at wes.ruggles@vickers-systems.com or call at (513) 494-5229 | | Thanks | Wes Ruggles | Hi Wes
Electronics Forum | Fri Sep 11 09:30:30 EDT 1998 | Earl Moon
| Heeeelllllp. | I am a sales rep. ( I know I know, you can't help me with that. ha ha.) Actually, I represent a company that fabricates PCBs and assembles them under the same roof. We are a small to moderate volume house that is just getting int
Electronics Forum | Thu Sep 03 15:43:18 EDT 1998 | Tim Flanagan
I need advice for locating 23 Gull wing LED's (all in a straight line) in the x,y, and z axis for a SMT PCB. It is a Hewlett Packard LED (P/N HMLA-QH00-01). The application uses a CCD to detect the position of a ball which floats in a resevior for
Electronics Forum | Thu Jun 04 14:47:56 EDT 1998 | Steve Gregory
Hi Tim! There are two belt feeders that I've worked with that I can comment on. You're right about vibe feeders, they're good for one thing as far as I'm concerned...they make okay boat anchors, not good, just okay....(GRIN) The two that I'v
Electronics Forum | Thu Jun 24 14:34:13 EDT 2004 | tjensen
There are many factors that can lead to solder balls. Since you have just recently seen this start to occur, it is obvious something has changed in the product or your process. Since we don't have a lot of details about your process, I would sugges
Electronics Forum | Fri Dec 08 19:09:44 EST 2006 | darby
I have just started production run using this component. After reflow I see that there is an undercut of solder between the pcb and the lead instead of a fillet. This means that some of the leads are sitting above the solder with no wetting to the co
Electronics Forum | Fri Mar 04 19:38:44 EST 2011 | olddog
We are a very small (2 people) company and have recently purchased a used Quad 4c Mk II, for our low-volume in-house production. The machine appears to work perfectly for our needs. My question is regarding programming from a concept standpoint. Our
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Thu Nov 17 15:57:41 EST 2011 | olddog
Hi Bobpan, Regarding "second", the results of the test are no difference - still rejects the part. I tried 2 mils, 3 mils, 5 mils, 7 & 9. I changed the tolerances fron about 15% to 20%+. By the way, I did put on the new nozzle and it is still the sa