Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Wed Sep 30 06:22:23 EDT 2015 | mervin
MPMENG, Thank you so much for taking the time to help. The machine has Y snuggers and flippers. The Pcb is loading in the center all the time. The driver cards look fine there is no obvious faults on them or partially burned. The machine was not in
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
Electronics Forum | Mon Jul 29 08:28:05 EDT 2002 | pjc
Start killing DEK now, on the ELA. All DEK 248 semi-auto printers have been built in China for quite some time (years). Its shipped to the UK from China. All DEK ELA models are now built in China, since 01 some time. Thats the fact Jack. All MPM mod
Electronics Forum | Fri Jul 15 02:26:47 EDT 2005 | fastek
OK...here's another one. The HiE designation began with UP-2000's I believe. And if I'm not mistaken the difference between a HiE and a non HiE was speed improvements as it related to axis movement times. If you could figure out a way to accomplish t
Electronics Forum | Tue Nov 26 09:19:29 EST 2002 | pjc
MPM UltraPrint 2000 2D Inspection Times: QFP 256 pin 16Mil pitch is 7.5 seconds BGA 225 ball 20Mil pitch is 1.8 seconds Find out the DEK times for these devices. Any UP2000 of 1995 mfg. date oand on can be upgraded to the latest software. Concer
Electronics Forum | Fri Mar 31 11:46:57 EST 2006 | fastek
Larry- I notice most of your posts either start out or end up like ......."I don't know anything about this, but there was a guy that worked here and he told me"...... WTF? You're not bringing anything to the table when you make judgements/opinion
Electronics Forum | Mon May 12 11:36:35 EDT 2008 | cyber_wolf
Harry,I know what you mean. You are completely right and justified. My father owns his own business and I see stuff like what you described all of the time. Yes we have done business before. I worked with you when you were with MPM and after you st
Electronics Forum | Mon Nov 25 20:57:23 EST 2002 | Kermit
Thanks to everyone who has responded so far. We are going with dedicated tooling for our phone cards but not for our system cards so that takes that out of the equation for the former, will evaluate for the system bds.. Thanks for the info.. Regard
Electronics Forum | Wed Sep 30 05:10:28 EDT 2015 | aemery
SWAG does make a good point. The tool he is talking about is located on setup page 1 in the vision box and is labeled FP Mode (Fine Pitch) mode. BY default the setting is "0" this means that once the machine is put into auto mode the camera or visio