Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Wed Oct 14 15:33:48 EDT 1998 | Justin Medernach
| | | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will
Electronics Forum | Tue Apr 18 06:15:49 EDT 2006 | JH
AJ, I have had the Solder Saver on trial a couple of times and reached the same conclusion both times - it is not for us. However there are benifits for some users. In case you dont know how it works, here is a brief explanation; The hand held to
Electronics Forum | Wed Oct 14 08:27:26 EDT 1998 | Earl Moon
| | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will i
Electronics Forum | Mon Apr 01 20:10:24 EST 2002 | davef
Oh. [Howabout if I smack you?] If ahma connectin� wif whut yer sayin�, you: * Don�t like the appearance of the glue slobberin� out from under the component even though there is no apparent glue on solderable surfaces. * Concerned about the hydrosco
Electronics Forum | Wed Feb 15 19:20:46 EST 2006 | Mr. Samir
Russ, On both instruments, I ran them through the wave 20 times each using identical profiles and wave parameters, and then used statistical formulas to measure the variation and repeatability of each. I had these all in Excel, but that was around 1
Electronics Forum | Tue Nov 15 14:01:00 EST 2011 | olddog
Well, everything WAS going OK until I started setting up for a board job (40 boards with about 450 components each - many image repeats). We setup 37 feeders with their parts and started defining the pickups and placements. Part #1 is an SOD123 zener
Electronics Forum | Mon Apr 26 16:14:08 EDT 1999 | John W
| Hi Murray! | | Justin pretty much summed things up...covered all the points. So I'm just gonna give you my preference of what I like other than HASL finish. | | Electroless Nickle/Immersion Gold...nice flat pads...hmmmmmmm, Steve likes flat pads.
Electronics Forum | Wed Nov 25 17:21:17 EST 1998 | Michael Allen
A word of caution: thick webs (i.e., shallow score grooves) can result in scrapped boards, especially if you've got the dual-wheel-type score breaking machine. I discovered recently that shallow score grooves, combined with DULL knife-edge guides on
Electronics Forum | Wed Mar 06 21:17:35 EST 2002 | davef
One, has anyone else ever experienced and dealt with a company debate regarding whether or not your reflow ovens should or should not be calibrated? Sure, it�s an excellent debating topic. We argue about stuff like this all the time. See, somebody