Electronics Forum | Fri Sep 01 09:54:02 EDT 2017 | gsmx4321
I get a Timeout waiting for nozzle changer vacuum buildup failure every time I go to run my 1998 GSMx machine. The problems seems to be that once in a while (it seems to be random) the spindle does not line up exactly in the center of the nozzle cha
Electronics Forum | Wed May 11 11:21:11 EDT 2005 | russ
Been getting wacked by lightning for twenty years in this business. (three times yesterday as a matter of fact) We have never shut down in anticipation that we are going to get hit. I have lost one motherboard in all of these years that cost about $
Electronics Forum | Mon Jul 17 15:35:09 EDT 2017 | svfeingold
Evtimov, I thank you for your response. I posted a thread about this on EEVBlog but there is less experience there for this type of equipment it would seem. If your interested there's a lot more detail about what I'm after: http://www.eevblog.com/for
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Wed Feb 11 00:34:42 EST 2015 | comatose
There isn't going to be much worthwhile used equipment out there if you mean true jetting - it is a pretty recent process. There are lots of used stencil printers out there, so from an up-front cost perspective, stencil wins. Jetting is slow. A hig
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Mon Jun 18 21:27:49 EDT 2001 | davef
Ah Wolfgang, just too much time in hand-to-hand combat. * If more than 5 percent of our troop where that way, they�d put out of business. * If my troop [even the boneheads] caught me disin them, I�d get: skunk-eye, dressed-down, told-off, and who k
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Tue Jun 20 16:41:12 EDT 2017 | kkrestchmer
We have a Speedline Electrovert Bravo 8 reflow oven. We have issues where we get a "thermal runaway HTSC trip" error and the oven shuts down. We normally can unplug and replug a connector into the Sensor/Relay Watlow AnaFaze TLM-8 module and it sta
Electronics Forum | Tue Apr 12 03:30:01 EDT 2005 | ianlg
Hi In regards to the screen printer you might like to check our Reprints R29-V semi automatic. For low to medium volume it would be perfect for your needs and being a 29" machine and able to print down to 01005 pads with ease. It has a digital zoom
