Electronics Forum | Tue May 10 20:38:04 EDT 2011 | wolverine
I am going to have to install new timing belts in a Samsung CP40 series machine, these are the belts that run on each side of the placement head gantry. Do not have technical support from Samsung nor do I have a service manual for the machine, just t
Electronics Forum | Fri Apr 12 18:10:57 EDT 2019 | davef
Here's what we've done in the past. Depending on how it's configured, conveyors can run either forward or backward, but only in one direction at a time. The voltage polarity through the starter of the drive motor configures the direction. So, swappin
Electronics Forum | Wed Apr 17 08:01:42 EDT 2019 | jfeustel
If this is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois then I've seen this before. The folks at Kanetic built a function into the PLC code to make the conveyor reversible without hardware modifications.
Electronics Forum | Tue Apr 23 06:26:18 EDT 2019 | jfeustel
Kanetic did implement a feature into their PLC code that would allow for simple reversal of the board flow. This is why the conveyor suddenly reversed direction after so many years. Because the feature was invoked by holding down a button it was kno
Electronics Forum | Mon May 11 17:03:05 EDT 2015 | dilogic
Any advice how to (easily) replace theta timing belt on GSM Flex head?
Electronics Forum | Fri Feb 18 22:14:24 EST 2022 | sarason
Yes something like that.ie a higher edge. Looking at your original picture I assumed no edge. If that doesn't work, then it is time to change the belt. But do check the frame with a straight edge. you may find a little twist or bend that may not be v
Electronics Forum | Thu Jan 28 22:05:26 EST 2010 | GMD
Is anyone using PanaCIM or SMS software, with Panasonic CM602 line configuration? We are looking at both software applications in order to collect real time data, create programs and keep track of inventory.
Electronics Forum | Thu Oct 22 05:36:58 EDT 2015 | myleb
Hi Nhel, It's quite strange problem here... 1. The voltage check: please supply power voltage. Inside machine (BF) there is a transformer, please make sure the voltage setup is correct. 2. In Ringload information, please see the 12V and 24V, is it
Electronics Forum | Wed Nov 26 15:01:07 EST 2014 | dhollland
No, guess I should have tried to explain it better. If I am trying to place a component at X-31.6 and Y52.8 What is the tolerance +/- that the machine will put it at that exact location. I know it's not going to place it at exactly that spot every
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
