Electronics Forum | Wed Dec 12 10:40:08 EST 2007 | ehess
Thanks Bruce. This method is working good for me, for now anyway. I'll have to see how good my splices hold up over time.
Electronics Forum | Fri May 03 12:06:55 EDT 2013 | ericrr
For your part you took the time and trouble to do Phil it is a tremendous help. But it might pay if I do not say anymore at this stage. Thank you Phil.
Electronics Forum | Sat Oct 08 19:06:32 EDT 2005 | Mika
Check the timing belt. I have running into a similar situation before. "1 notch of" of the timing belt can cause very strange behaviour of the machine. /Sincerly Ps. let us know your progress. Ds.
Electronics Forum | Mon May 11 17:03:05 EDT 2015 | dilogic
Any advice how to (easily) replace theta timing belt on GSM Flex head?
Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Sat Mar 28 12:25:48 EDT 2009 | gpaelmo
We have an MPM SPM-AV screen printer and we need to replace the Z-axis timing belt. P/N of timing belt is P2387. Anyone know what the length is does not specify in manual? And instructions on how to remove and replace it? No mention in MPM maintenan
Electronics Forum | Tue May 10 20:38:04 EDT 2011 | wolverine
I am going to have to install new timing belts in a Samsung CP40 series machine, these are the belts that run on each side of the placement head gantry. Do not have technical support from Samsung nor do I have a service manual for the machine, just t
Electronics Forum | Fri Apr 28 02:10:19 EDT 2017 | bukas
i'd say its a ball nut. maybe it came loose or the balls are worn out. also, check timing belt! if resonance is periodical like you say then there is great probability that belt or/and belt pulleys got worn out. i had combination of these on one of m
Electronics Forum | Sat Apr 21 21:20:56 EDT 2007 | mika
Hi, Go for a very "slow down" turrent speed of 50 % and then see what is happening? It sounds that You could face a timing belt problem. I have seen this before. Another thing on this machine is whenever a slitghest misalignment between the the diffe
Electronics Forum | Wed Apr 16 07:31:45 EDT 2003 | brobinson
Anybody know a site that lists example oven profiles? I am looking to write a profile for 120 C for 15 minutes through a Vitronics Soltec XPM Reflow oven. Rather than guess, a rough starting time for belt speeds would be nice.
