Electronics Forum | Wed Feb 02 17:16:44 EST 2000 | Larry
Boca, We mix them with titanium fingers, been running them for 6 months with no problems with heat. They break off rather then mangle like the titaniums, which can be a good thing! Do I like them? Sure! I found they were 1/2 the price as titaniums an
Electronics Forum | Mon Jan 31 10:21:27 EST 2000 | boca raton
I've seen some plastic fingers advertised for wave solder machines. Anyone used 'em? They are 'glass-reinforeced polymer resin', they are supposed to stand the heat, can be mixed with titanium fingers on the machine, and cheaper! (near and dear to
Electronics Forum | Tue Jun 23 17:03:10 EDT 1998 | Ken Chase
Yes, New Era Technology, Inc. is a manufacturer of Titanium fingers for Hollis and Sensbee wave Solder machines, as well as a other products. give them a call @ (603)669-7971 for more info.
Electronics Forum | Fri Jan 14 09:36:49 EST 2000 | Richard
If the gold fingers are pad types which plug into expansion slot connectors, I have used a titanium guard attached to the wave conveyor over the solder pot, which allows the PCB to connect to the fingers but masks the solder from the gold pads along
Electronics Forum | Thu Jan 13 13:16:40 EST 2000 | Dave F
Tony: You have choices: * Hi Temperature Tape: Go with Wolfgang ... too tough to control. * Selective Soldering Pallets: Some like 'em some don't. A lot of your success depends on the pallet fabricator. * Screenable Temporary Solder Mask: Wol
Electronics Forum | Thu Jun 04 09:29:21 EDT 1998 | Chrys
I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and r
Electronics Forum | Thu Jun 04 11:09:50 EDT 1998 | Justin Medernach
| I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and
Electronics Forum | Wed Jan 27 20:34:13 EST 1999 | parag palshikar
| | hi, | | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier pr
Electronics Forum | Sat Jan 23 16:07:20 EST 1999 | Steve Gregory
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Thu Aug 21 18:10:06 EDT 2008 | osp2008
Hi, Have you been able to find nate source of wave soldering fingers?I have just started this company and we carry technical devices wave solder finger. Each made of 100% pure titanium and 0.1mm thicker. If you need to try one out of my products .
