Electronics Forum | Thu Dec 03 03:13:11 EST 2015 | polar121
Hi has anyone had a fault with a soltec deltawave model 6622cc were the following functions all turn off for no reason Preheat zone1 and 2 the fluxer and the solder wave pump this has been happening for the last couple of weeks and seems to be getti
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Tue Feb 08 19:10:09 EST 2005 | DasonC
Lead free is not define as NO lead and "a maximum concentration value of 0.1% by weight in homogeneous materials for lead shall be tolerated." Check below link. So replaced your solder from the pot when exceed 0.1%. http://www.leadfree.org/files
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Mon May 10 08:00:14 EDT 1999 | Timothy O'Neill
| | | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so
Electronics Forum | Tue May 04 14:42:58 EDT 1999 | Chrys Shea
| | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I wi
Electronics Forum | Mon May 10 07:53:48 EDT 1999 | Timothy O'Neill
| | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I
Electronics Forum | Tue Oct 13 12:32:43 EDT 2009 | davef
2.6.3 Test Pad Location Tolerances, third bullet. Why does Entek require different test point spacing than other surface finishes? Page 55, top image is off the page, partially. 2.3.6 Depanelization of Arrays, 10th bullet [Breakaway Scoring] refers
Electronics Forum | Tue Nov 02 23:34:58 EST 1999 | chartrain
You appear to have two problems working against you at once. One is component lead corrosion that the no clean flux isn't aggressive enough to remove. Do a simple dip and look test. Flux the leads of a component and dip it into the molten solder for
Electronics Forum | Wed Feb 21 09:23:11 EST 2007 | electronhose
Probably not on the whole job, but maybe the 1-5 boards that were used for setup control. Especially MELF's are not super process tolerant. I'd probably allow standard caps and resistors one more time, but I'd need some test data to back it up. I'd