Electronics Forum | Fri Aug 01 00:22:46 EDT 2008 | fowlerchang
Pattern design, paste volume,printing misalignment, place misalignment,reflow process include N2 usage. All the factor above can make tombstome happen. And the most important factor is placement misalignment except design issue. But pls check the sol
Electronics Forum | Fri Aug 01 02:10:26 EDT 2008 | fowlerchang
Pad design is not only the size of pad but also the distance between two pad. N2 will increase tombstone as we tested. 10 zones reflow oven and slow temperature ramp will reduce this defect. MustII is the equipment which is used to test the solderabi
Electronics Forum | Fri Aug 01 00:40:06 EDT 2008 | roc2x
thanks,my pad design is 24 x 23 mils and now I chnged my stencil to 24 x 20 mils ship inwrds to lower down my volume. My placement is and part data are ok. My reflow N2 is using 1000ppm, Actual is 700-800ppm I already prolonged my pre-heat butit only
Electronics Forum | Thu Aug 24 09:41:46 EDT 2000 | Dr. Ning-Cheng Lee
The optimal profile to choose is determined by the following factors, (1) thermal mass and distribution across the board, (2) reflow temperature range needed for a particular alloy, (3) the nature of flux. When the thermal mass is small, such as cell
Electronics Forum | Tue Sep 09 12:05:44 EDT 2008 | tonyamenson
First and fore most is to find your paste manufacturer spec sheets. Read it over several times and let it all sink in. Then call them with questions as they want to keep your business so their engineers want to help you use their product. I assume y
Electronics Forum | Tue Feb 19 09:24:25 EST 2019 | cyber_wolf
Reflow profiles are based on the product and materials you are soldering. You need profiling software and a data logger.
Electronics Forum | Thu Aug 24 08:59:38 EDT 2000 | Eugene Smelik
Dr. Lee, For Pb-free solders, will the reflow profile be similar to that of Sn/Pb, with an flux activation plateau before going to peak reflow, or will the profile be more linear in nature? Are there advantages/disadvantages to either profile for P
Electronics Forum | Tue Feb 19 08:41:02 EST 2019 | prasanth
dear experts, i want your suggestion for getting a profile in Heller 1707 mk iii series re-flow machine ,its 7 zone machine recently we had a solder ability issues , so pls guide me ,how to set rts profile parameters
Electronics Forum | Sat Sep 22 09:07:56 EDT 2001 | davef
Back-stepping a bit. If a profile is being used to: * Set-up the oven for a new product or trouble-shooting process, the profile should be taken with a solid contact to a solder connection. * Monitoring on-going stable and in-control process that re
Electronics Forum | Fri Sep 21 09:29:49 EDT 2001 | steven
when taking a reflow profile, can i attach the thermalcouple to the component body (using high temp tape) instead of to the leads (often found thermal couple dettached during reflow). in general, what is the temp diff between these 2 locatinos. if so
