Electronics Forum | Mon Aug 23 20:06:49 EDT 1999 | Peter
I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached t
Electronics Forum | Mon Aug 23 20:56:29 EDT 1999 | Dave F
| I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached
Electronics Forum | Tue Aug 24 15:06:06 EDT 1999 | John Thorup
| | I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attach
Electronics Forum | Tue Sep 05 08:40:33 EDT 2006 | CL
SMAINTECH, Good Morning, We have installed the Gridlock tooling pin with stealth mode on our DEK's. It is a hard tooling pin array that resets the height if the pin for every board. The pin comes up until it comes into contact with something then lo
Electronics Forum | Wed Sep 06 06:12:57 EDT 2006 | jonatf
thanks CL, Any idea how much the Gridlock tooling pin is? Brand new or seconds??? cheers!
Electronics Forum | Wed Sep 20 15:56:44 EDT 2006 | Rapid
There is a quick change dedicated tooling solution. It involves a "h-tower" and a machined vacuum (or non-vacuum) plate. There are two 8mm threaded holes on the table that are there for support tooling interface. The tower or tooling bolts to thos
Electronics Forum | Tue Aug 04 12:12:04 EDT 1998 | Steve A
| We are looking for source(s) for tooling pins: | 1 Stainless steel pin | 2 0.120" diameter, 0.250-0.375" long | 3 Press fit We have been buying .122" dia SS tooling pins from Danley Punchrite. Their number is 1-800-232-6592. The problem is tha
Electronics Forum | Tue Aug 04 08:29:06 EDT 1998 | Dave F
We are looking for source(s) for tooling pins: 1 Stainless steel pin 2 0.120" diameter, 0.250-0.375" long 3 Press fit
Electronics Forum | Thu Jun 03 14:12:25 EDT 2004 | russ
Thanks Rob, $7k, for a bag of silly putty with a magnet! This is supposed to be the same cost as tooling pins and much cheaper than dedicated tooling? I can't remember ever spending 7k on tooling unless I had 20 unique plates made. I wonder how ma
Electronics Forum | Fri Apr 02 16:31:18 EST 2004 | black5629
Why not use tooling pins (locating pins)? Sounds like the same accuracy...
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
winsouce.jpg)
