Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Thu Mar 20 15:57:57 EDT 2014 | edwaterfall01
The numeric display number should be higher but only when all 7 spindles are moved down slightly from the full up position. The 7 spindles retract up to the Stop Bar. Each spindle assembly has a tapered hole thru it. This hole is in the block with t
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Mon Nov 19 15:21:44 EST 2007 | wayne123
I was not trying to imply that you didn't know how to run these machines I was simply saying that alot of problems that people may encounter can be solved with operating them correctly, I am sorry if you took offense to this, I too have performed all
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Tue Feb 12 10:51:46 EST 2002 | stefwitt
Dave is right. There is no machine on the market which can handle a 1.5 m long "board". If you or someone else will have to tinker with a custom made machine, it will be less expensive to use a used machine ( I could be offering some used Siemens mac
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
