Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Mon Nov 19 15:21:44 EST 2007 | wayne123
I was not trying to imply that you didn't know how to run these machines I was simply saying that alot of problems that people may encounter can be solved with operating them correctly, I am sorry if you took offense to this, I too have performed all
Electronics Forum | Sat Jul 08 09:19:53 EDT 2006 | Larry
Samsung vs. Assembleon We currently have both Samsung/Dynatech and Assembleon Equipment. We started with two Samsung machines but the support, flexibility, component range, accuracy and speed of their machines just wasn�t there. The difference betw
Electronics Forum | Fri Jul 07 13:32:30 EDT 2006 | David
Hello We have notorious problem with TopazXi FNC head and bending head number one shaft. So far service can't find the root of problem. Looks like problem is related with nozzle station and head hit the station. All sensor head down, nozzle are co
Electronics Forum | Wed Feb 13 14:06:35 EST 2019 | slthomas
My recollection is fuzzy, but don't the heads go down first, then the nozzle? If that's true, did you fire the heads only or both the heads and the nozzles?
Electronics Forum | Fri Jul 24 07:56:40 EDT 2009 | thanhnguyen
hello all I have a Assembleon Topaz. at head # 2 everytime it going down to pick up the part, it just blowing the part off from feeder, i did replace vacuum vale but still doing the same. any input is helpful. thanks
Electronics Forum | Mon Feb 20 13:43:54 EST 2012 | acsscott
Having a problem at power up, that our Philips Topaz X displays "DOWNLOAD IO STN.DATA NG" in red. It times out after about 5 minutes, then comes up. When we try to find the origin, it gives an error that the "Head Down sensor is OFF". If we go int
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a
Electronics Forum | Mon Oct 08 05:48:36 EDT 2012 | vinitverma
Dear Chris, N2324 and N2325 are for nozzle down sensors. THese sensors are located on the left and right side of the left and right walls of the head assembly respectively. There are very small holes in the walles through which these sensors transmi
Electronics Forum | Fri May 10 01:42:13 EDT 2019 | vinitverma
A Table is something that you can ignore right now. It is significant only in case of dual table machines such as Sapphire or Sapphire-X which have A and B tables (two independent PCBs being handled at the same time). In case of Topaz or Topaz X or E
