Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Mon Feb 20 14:56:22 EST 2012 | acsscott
Ok, so we figured out that if the LCS is connected, we don't get the error. So, the HDLC data buss gos out and back, or is terminated in the LCS. How to remove the LCS? We try to go into maintenance screen to change the machine configuration, and
Electronics Forum | Tue Feb 21 10:15:07 EST 2012 | vinitverma
Forgot to mention. To disable the LCS you need to disable it in the machine config - by changing Tray Changer to NONE. Of course for this you will need the password which is "specialist". After setting this in the software, you also need to remove t
Electronics Forum | Sat Feb 26 13:56:22 EST 2022 | poly
I was looking to swap a Universal GC60 from 240 to 400 V 3 phase. I can get a transformer though and just looked at prices and they are quite cheap. My 2 main options at the moment: Option a: 1 Universal Genesis (2006) some feeders + essemtec ove
Electronics Forum | Mon Feb 04 17:53:58 EST 2019 | arbpkevin
My topaz X does the same thing. Hope someone can explain this. I have to toggle the button every single time after the first board.
Electronics Forum | Fri May 27 14:15:21 EDT 2005 | ve7khz
Hi Folks, Starting a second SMT line this year and it's been (too) long since I have looked at newish machines and I am in need of some assistance with P&P machine selection. Here is what we currently have: Panasonic CM-202 chip shooter 216 8mm reel
Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Tue Feb 21 11:43:08 EST 2012 | vinitverma
What I can tell you for sure is that if you are able to run the machine with the LCS connected, then with the config settings changed to NONE and the connector shorted (with the connector already present), it should work for sure! I've done this myse
Electronics Forum | Wed May 13 10:34:57 EDT 2015 | squeekypigeon
If memory serves me right, if you are test picking a component which will be served to the machine via an LCS the 'pick position' will automatically set itself to feeder slot 1. If you change this to something more central (I used to use location 4
winsouce.jpg)