Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Wed Jan 14 22:19:18 EST 2004 | Dean
It's called VIOS. It can be run on a PC. But, it must be massaged considerabley as there is no I/O, servo or master cards in communication. Consult Assemblion for details. Remember, altering their software without express permission could put you i
Electronics Forum | Thu Mar 24 22:57:32 EDT 2022 | glasscake
Issue was solved by replacing servo motor/encoder wiring harnesses. Hooking a scope up to the head showed we were losing steps.
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Mon Feb 04 17:47:20 EST 2019 | arbpkevin
When I power up the machine and it finishes booting into VIOS, I normally hit the ready button to power up the drives so I can perform the origin search. Instead of "latching on" the contactors pull in, and then quickly release. If you hold down th
| 1 |
winsouce.jpg)