Electronics Forum | Fri Feb 25 16:23:10 EST 2000 | Russ
Assuming that you need information such as the type and size of screw to the recommended torque value. I have found great information from the torque tool manufacturers themselves! There is an ANSI spec but I don't know the specifics. Your torque d
Electronics Forum | Fri Feb 25 16:23:10 EST 2000 | Russ
Assuming that you need information such as the type and size of screw to the recommended torque value. I have found great information from the torque tool manufacturers themselves! There is an ANSI spec but I don't know the specifics. Your torque d
Electronics Forum | Thu Dec 07 14:23:30 EST 2006 | russ
I wuld say it is attachment method and post install force that is the problem not the size of the heatsink. we place heatsinks that are at least 5 times the size of BGA with no issue, they are attached with very precision torque drivers. Russ
Electronics Forum | Fri Oct 18 11:32:15 EDT 2002 | yngwie
Hi Experts, Here in Box builds area, there was an argument on frequency of verifying torque reading. Shiftly changed to daily and now we are changing it to weekly. The reason for relaxing this frequency is b'cos the data we collected shown that the
Electronics Forum | Fri Oct 18 11:33:25 EDT 2002 | yngwie
Hi Experts, Here in Box builds area, there was an argument on frequency of verifying torque reading. Shiftly changed to daily and now we are changing it to weekly. The reason for relaxing this frequency is b'cos the data we collected shown that the
Electronics Forum | Fri Sep 09 05:27:41 EDT 2016 | jasltd
Bud, hard to say without looking at bom / drawings & what manning you have avaiable to figure out what you need to put in place to get the build rate you need. is the cabinate supplied as is or do you have to build that as well? You'll need some ele
Electronics Forum | Wed Jan 30 13:45:59 EST 2019 | slthomas
I'm wrestling with the infamous adjustable torque drivers on the production floor. Despite a procedure that clearly forbids it, we still have the occasional know-it-all that will just crank the knob until the desired setting is visible in the windo
Electronics Forum | Thu Aug 30 22:36:36 EDT 2001 | davef
While I don't understand why, this topic comes-up fairly often on SMTnet. [That the topic recurs indicates there truely is a problem and I'm just too doopy to understand it.] Several things: 1 Check the fine SMTnet Archives. 2 Some glue suppliers kn
Electronics Forum | Fri Oct 18 21:42:04 EDT 2002 | caldon
We did weekly and monthly. Final assembly (Heavy use) recieved weekly. Field service area, sub assembly, low volume, ..... we went monthly. I wrote the ISO specs to read "Calbration of screw drivers to be monitored and logged"( this Simplified of
Electronics Forum | Wed Jan 17 20:48:14 EST 2001 | davef
We find that the raw BGA's pad sheared surface has the SnPb solder at various Z heights whereas the assembled BGAs pad leave a smooth layer of SnPb along the pad. Like to understand the cause for the difference. Who could guess? Solder joint streng
| 1 |
winsouce.jpg)
