Electronics Forum | Thu May 20 11:04:31 EDT 2004 | SWagner
I do not think it's your power supply, its probably the monitor, I spent two days nearly four years ago on this problem, the 265's power supply can be dropped out by a problem with any of the voltages, they are not isolated. Try using a known good c
Electronics Forum | Wed May 19 16:48:23 EDT 2004 | SWagner
You might have something dragging down your power supply, I have had the color monitor do this when it approachs the end of its life span, I have also had the power supply itself go bad but the voltage is usually 0. Unplug the monitors and see what
Electronics Forum | Thu May 20 16:14:55 EDT 2004 | jsk
UP AND RUNNING!!! Power supply is good but i found two loose wires in connector 12PL26 (DC to Y1). I think i may have another bad connection inside the Y1 enclosure. Monitor seems to be working OK. Thanks for your help, jsk
Electronics Forum | Wed Sep 26 00:24:14 EDT 2012 | elefu
The bulb is bright but nothing shows on the screen. It will not see anything above it. If I put an LED by it the light shows on the monitor. Any ideas?
Electronics Forum | Thu May 20 09:20:08 EDT 2004 | jsk
Voltage checks out ok after i unplug the monitor and unplug the dc voltage suppy to the y1 enclosure. I lose the 24v and 5v line completely when i plug these in and voltage drops on the +12v and -12v, which leads me to believe a bad power suppy. What
Electronics Forum | Thu Aug 23 09:44:09 EDT 2018 | midware
Hi. Please help. On DEK 265 GSX i've got on the monitor message: "DEK 265 GSX Motor comms failure, card 1, axis 123 fatal error." F1-F8 doesn't work, machine cant start. No result after Reinitialise machine. Which one is this card1? Is it in PC?
Electronics Forum | Wed Apr 11 11:26:30 EDT 2012 | aj
I would recommend that you disconnect the colour monitor and replace it with a standard one.... these monitors are dodgy as hell and cause untold problems throughout the power circuitry...try it and see how you get on...
Electronics Forum | Fri Aug 12 18:39:21 EDT 2022 | magsat
Hello, please help, On DEK 265 GSX I have on the monitor: "Downloading vision system" and then nothing happens (no error comes up)
Electronics Forum | Wed Aug 31 07:40:58 EDT 2016 | bukas
BIOS stopped loading, now when I start machine monitor doesn't receive any signal. tried to start machine with different hard drive but nothing
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
winsouce.jpg)
