Electronics Forum | Tue Aug 14 08:44:44 EDT 2012 | ducati
HI, we use the SMT Tower software to controll it. The Tower is afully automated storage which controlls the humidity. Is a component leaving the Tower, the time is runnig. Is the Component back in the Tower, the time is stopped.
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Tue Jul 10 13:01:02 EDT 2018 | john22hendy
Looking for any Preventative maintenance steps for SMD storage towers. The MyCronics Owners manual does not specify PM suggestions, however proper vacuuming, lubrication and lens cleaning is necessary. Does anyone have other items to suggest or a li
Electronics Forum | Wed Sep 20 15:56:44 EDT 2006 | Rapid
There is a quick change dedicated tooling solution. It involves a "h-tower" and a machined vacuum (or non-vacuum) plate. There are two 8mm threaded holes on the table that are there for support tooling interface. The tower or tooling bolts to thos
Electronics Forum | Thu Jan 25 13:54:51 EST 2018 | emeto
The best way is to have proper system in place that shows which reel is stored where. Now mycronic, juki, fuji and more have these towers(MSD), where you can keep your parts in. It is a very elegant solution with a beautiful software that tells you w
Electronics Forum | Wed Dec 14 13:44:14 EST 2022 | assuredtech
Do you have the electrical schematic? The matting connector should be right there at the machine frame just under the mounting hole for the light tower. Light Towers can be an "option" on machine configurations, perhaps your machine was not configure
Electronics Forum | Mon Jun 19 13:00:16 EDT 2006 | fabio
"Z tower obstruction - machine must reset". I�m having this problem in the machine... please help!!
Electronics Forum | Wed Apr 08 18:47:57 EDT 2009 | swag
Could be the z-axis driver card???
Electronics Forum | Mon Apr 13 16:06:36 EDT 2009 | soudomphong
I thought AP-25 was old. Good luck!
Electronics Forum | Sun Jun 25 00:33:13 EDT 2000 | Robertsam
I had problembs with taping the signal to on the buzzer with machine tower light.However I try to connect parrallel to the light but the control board which connected to the light malfunction after 1/2 hour.The tower light is trigger by the ground s
