Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Mon Nov 14 12:11:20 EST 2005 | binhanhaokiet
We just bought a used TP9-2U, I could not do a W-wagon camera calibrate. It keep saying "Calibrate failed, can't located all point", I do not know what should I do next. I did refocus the camera but it still does not help. Please help
Electronics Forum | Thu Oct 27 20:37:49 EDT 2011 | tech1
the calibration error sounds like it is an electrical verifier issue. Are you testing parts before you place them? It could be that your centering electrodes are worn or dirty, or it could be the ribbon cables from the centering unit. If you are usin
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Mon Nov 14 12:17:17 EST 2005 | avalancher
You should contact MYDATA service department and see what advise their phone support people can offer. You may not be doing the process correctly (wrong calibration boards, etc...)
Electronics Forum | Sat Oct 29 02:13:27 EDT 2011 | darrenj
Hi, We had a video-related problem and I had to shutdown the machine a few times un-expectedly. Now, the video seems to be fixed (bios config problem), but the machine boots up and says that the serial number is -1 which does not match the calibrati
Electronics Forum | Tue Nov 15 16:57:22 EST 2005 | bk
If your problem is happening part way through the calibration the problem might be there is too much friction from your Y-wagon. Measure the friction on the Y-wagon using the service program if it fails or if it is near the max allowed try oiling up
winsouce.jpg)