Electronics Forum | Mon Feb 27 23:02:55 EST 2012 | ev
We have a TP-11 and this error occurs at the start of the insertion pattern hence we can't run. Any suggestions for correction? Thanks, Ev
Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk
I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with
Electronics Forum | Fri Apr 28 21:37:54 EDT 2006 | chrisgriffin
Check the resistors on the circuit board. It is also very likely that you have blown the crystals in the transducers. How big is the unit? What is the frequency of the unit(transducers). These can be tricky to troubleshoot, but replacement transdu
Electronics Forum | Fri Oct 12 11:21:43 EDT 2018 | tech1
There are 2-X motors and numerous items that could be causing this: 1 of the X motors, 1 of the X transducers, 1 of the couplings connecting the motor and transducer, X Kevlar Belt. If you know how to go into the service portion of the software you
Electronics Forum | Tue May 16 22:48:09 EDT 2000 | Dave F
Dustin: try:
Electronics Forum | Fri Feb 14 16:55:07 EST 2020 | bilalfarooqi
Thanks so much Bruce and thanks Rob.
Electronics Forum | Fri Mar 11 09:42:50 EST 2005 | cyber_wolf
If you are not getting repeatable transducer readings then some possiblities are : 1. Transducer is bad 2. Motor is bad 3. Y power booster Also, I can't remember if the Y motor has a flex coupling on it or not. If it does, check that out. Also, w
Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Mon Oct 05 08:19:13 EDT 2009 | rgduval
We've been having random transducer errors on our TP recently. After speaking with MyData tech support, we were told the answer could be: 1. the transducer(s), 2. something causing undue friction, 3. something undiagonsed yet. Their recomendation
