433 transfer tray parts results

Electronics Forum: transfer tray parts (Page 1 of 44)

jedec tray tape

Electronics Forum | Tue Jul 07 04:11:10 EDT 2009 | smt99

any suppliers/ part refs would be great

OPAL XII tray feeder

Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh

REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.

"cut tape" tray

Electronics Forum | Tue Nov 17 10:55:17 EST 2009 | tpappano

I have a CSM84VZ, so I was thinking of a device that could be placed on it's "manual tray feeder" instead of one of the 9" wide plastic matrix trays that TQFPs, etc. are supplied in. The machine would be programmed to pick parts from several single-

internal tray feeder

Electronics Forum | Mon Feb 12 18:53:15 EST 2007 | Cmiller

They must have ended up with a bunch of them in stock because they never quoted a price that low to us, of course Im getting older and my memory is not that great anymore. If you have even decent machine shop, make your own. The factory one is made o

Heat transfer properties of encapsulate potting material.

Electronics Forum | Tue Dec 28 03:59:06 EST 2010 | riscy00

I'm investigating heat transfer by 1st order approximation between PCB and ambient air via encapsulate material (epoxy or gel or silicone), they have thermal conductivity of 0.2W/C but it hard to find specific heat capacity and density. Has anyone

Need a non-static generating adhesive transfer material

Electronics Forum | Thu Mar 27 16:40:45 EDT 2008 | slthomas

(or just some static-safe foam tape) I need to seal a wire terminal block to a board for conformal coating purposes. Currently we glue it to a shim and glue the shim to the board (yuck), but I want to use die cut gaskets if I can make it cost effec

Yamaha YV100 - Manual tray setup

Electronics Forum | Thu Mar 30 00:47:57 EDT 2017 | mrpackethead

I am trying to set up a YV100ii machine to pick up TQFP's from a manual tray. No matter what i do, it doe snot want to pick up the parts from the tray, but it keeps wanting to try to pick up parts from the place that a feeder would present the part.

Matrix/Jedec tray changeover at pick and place surface mount.

Electronics Forum | Tue Oct 12 13:03:18 EDT 2021 | cunningham

Afternoon all, Do you use any special surface other that ESD matting when changing over matrix trays? We currently use a earthed wire trolley that we keep trays and MSD bags on and when replenishing stock its carried out on the trolley. Does anyon