Electronics Forum | Fri Jul 15 14:45:20 EDT 2011 | cyber_wolf
http://www.vossbelting.com/
Electronics Forum | Wed Jul 13 13:48:12 EDT 2011 | markhoch
I've bought conveyor belts from Michigan Industrial Belting. http://www.mibelting.com They were able to make some custom belt sizes for me that I couldn't find anywhere else.
Electronics Forum | Wed Jul 13 14:24:43 EDT 2011 | leemeyer
Look at http://www.habasit.com. They sell the belt and the tools to cut and join the ends. I remember looking into this several years ago and the cost of the tooling was so high that it didn't make sense for us to make our own belts.
Electronics Forum | Wed Jul 13 13:23:34 EDT 2011 | kkay
We have multuiple pcb transport conveyors that use the 10mm wide flat green blets on either edge. Does anyone know of a kit to purchase where we could make our own or a company that supplies different sizes? Thanks
Electronics Forum | Tue Oct 07 12:40:57 EDT 2003 | ssnow
OEM no longer in existence. hard to find exact match. belt is flat and green. used for PCB transport.
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Electronics Forum | Mon May 18 14:46:38 EDT 2020 | dnachristen
Hello, We are looking for sources to keep our old Comtra Belt Feeders going for our Assembleon equipment. Mainly the belts that transport the component forward. Comtra went out of business years ago and parts are no longer available. I'm just looki
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
Electronics Forum | Mon Aug 24 17:05:51 EDT 2020 | kumarb
Aurash, we own Yamaha machinery but just throwing it out there...are the movements of the motors smooth or with friction? Is it possible that the linear screw rods (as in our machinery) require to be lubricated? There are special lubricants for each
Electronics Forum | Sat Aug 24 08:01:28 EDT 2002 | kumarraju
Hi CS Tan, Most customers expecially tend to neglet maintenance of the machine. As in the case of Dek 288 most of the end users have the impression that the 288 is one of the worst machines by Dek. But till today although Dek has discountinued manufa