Electronics Forum | Wed Jul 13 13:48:12 EDT 2011 | markhoch
I've bought conveyor belts from Michigan Industrial Belting. http://www.mibelting.com They were able to make some custom belt sizes for me that I couldn't find anywhere else.
Electronics Forum | Wed Jul 13 14:24:43 EDT 2011 | leemeyer
Look at http://www.habasit.com. They sell the belt and the tools to cut and join the ends. I remember looking into this several years ago and the cost of the tooling was so high that it didn't make sense for us to make our own belts.
Electronics Forum | Fri Jul 15 14:45:20 EDT 2011 | cyber_wolf
http://www.vossbelting.com/
Electronics Forum | Wed Jul 13 13:23:34 EDT 2011 | kkay
We have multuiple pcb transport conveyors that use the 10mm wide flat green blets on either edge. Does anyone know of a kit to purchase where we could make our own or a company that supplies different sizes? Thanks
Electronics Forum | Tue Oct 07 12:40:57 EDT 2003 | ssnow
OEM no longer in existence. hard to find exact match. belt is flat and green. used for PCB transport.
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
Electronics Forum | Mon May 18 14:46:38 EDT 2020 | dnachristen
Hello, We are looking for sources to keep our old Comtra Belt Feeders going for our Assembleon equipment. Mainly the belts that transport the component forward. Comtra went out of business years ago and parts are no longer available. I'm just looki
Electronics Forum | Thu Mar 30 07:44:19 EST 2006 | Chunks
UP 2000 is a good printer. Spares are normal - blades, stencil/board light bulbs, the over head flourecent, get new conveyor belts. Take the cover off the tactile sensor and make sure it's clean also. Other than that it should be a work horse.
Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
