Electronics Forum | Fri Sep 25 17:07:57 EDT 2009 | kircchoffs
does anyone knows how to calculate a correct fluxer traverse speed if given a spray width,pcb width & length and wave conveyor speed? thanks
Electronics Forum | Wed Sep 30 13:13:16 EDT 2009 | mikesewell
I never calculate it when I setup a profile...I have a feel for our fluxer setting and adjust based on belt speed and width. I also have different nozzles and a pressure setting to play with. Inspect the bottom of the board for good coverage. Runn
Electronics Forum | Wed Sep 30 20:07:14 EDT 2009 | davef
Find: Spray Fluxing for Pb-Free Wave Soldering; S Arora & S Soderstrom; Circuits Assembly; September 1, 2005
Electronics Forum | Wed Apr 07 13:10:36 EDT 1999 | Chrys Shea
| I am getting ready to purchase a spray fluxing system for a no-clean process. I have narrowed it down to the Nordson or Dover system. Does anyone have any experience with either. If so can you relate with me. I am a little leary of the Nordson
Electronics Forum | Mon Aug 22 11:49:59 EDT 2005 | pjc
Fixed spray head performance depends on board width. If you are looking for complete top-side hole fill, the flux penetration into the lead-hole will be more in the center and less on the ends because of the fan pattern spray. For board widths over 6
Electronics Forum | Tue Sep 29 11:54:28 EDT 2009 | mikesewell
Here's a stab at it... Decide on how much overlap you need for your spray pattern and calculate your effective spray width. 4" spray with 25% overlap would be 3". Keep your units the same (unit lengths and unit length per unit time). Assumes your
Electronics Forum | Thu Apr 08 13:24:36 EDT 1999 | ADRIANO FERNANDES
| | I am getting ready to purchase a spray fluxing system for a no-clean process. I have narrowed it down to the Nordson or Dover system. Does anyone have any experience with either. If so can you relate with me. I am a little leary of the Nordso
Electronics Forum | Fri Apr 12 16:13:36 EDT 2002 | pjc
Dave, USI makes spray fluxers with stepper motor and servo motor controlled traverse heads that only spray on the board. Virtually no waste going up the stack. www.ultraspray.com
Electronics Forum | Wed Apr 20 10:28:34 EDT 2005 | James
Anyone know of a place to get the vacuum pads for the traverser of the LCS units? Assembleon want over $100 each for a ring of ESD foam! ! ! ! If I can't find a reasonable source I guess I will try to make them myself. James jseagle@zworld.com
Electronics Forum | Tue Sep 29 15:53:56 EDT 2009 | davef
We don't know of a calculation, but we run ours as fast as we can while still getting good hole fill.
