Electronics Forum | Thu Jan 12 11:41:02 EST 2012 | babe7362000
We are recieving many QFN's in Tubes instead of trays and tape. Does anyone have luck with these in a tube feeder, or vib plate? We cant justify to order a full reel because the cost of the part.
Electronics Forum | Tue Feb 15 14:25:08 EST 2000 | Sergey
Dear Sirs Good business day! I need the following feeders for CSM60 machine: - Stick feeders: 1. 20 mm x 1 2. 13 mm x 3 3. 8mm x 7 - Tape feeders: 1. 16 mm, 9" x 7 you seems to be have not this 2. 24 mm, 9" x 3 3. 32mm, 9" x 1 - Manual tray feeder
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Thu Sep 19 14:25:30 EDT 2002 | stepheno
Changing the pitch on the newer feeders is a little bit different and involves adjusting the location of a sensor. Where we lose the parts is at change-over. There are some reels that we might put on and take off a feeder 20 times before the reel is
Electronics Forum | Fri Jan 16 07:48:29 EST 2004 | Mika
We usually program the components in the component database with pin 1 in the lower left corner. Then in the feeder database we set the component orientaion to 270 deg for Tray feeders(turn the tray in the feeder 180 deg) and "tube" feeders. For tape
Electronics Forum | Fri Jul 16 09:03:40 EDT 2004 | russ
A couple of thoughts, 1. buy larger quantity reels and load more trays of the same P/N if your problem is replenishing the machine. 2. If you're talking about changeover I would suggest that the feeders be set up in the kitting process and deliverd
Electronics Forum | Thu Jul 15 22:24:48 EDT 2004 | rohman23
I am interested in getting feedback from anyone who has or is reeling different parts on the same reel for pick and place. Our department is extremely high mix, extremely low volume. I am also very new to surface mount, and any experience with this
Electronics Forum | Mon Jan 31 15:02:52 EST 2005 | gs
First of all ask your Suplliers to provide you SMD in Tape & reel, second point, you can ask Service for Tape & Reel or in case components are not so many, you could asses ef convenient to buy a sinple maual Tape & Ree machine and do it inside your f
Electronics Forum | Fri Jul 31 17:03:21 EDT 2009 | isd_jwendell
My Essemtec machine can use "restband" feeders. They are manual feeders that simulate trays, but are specifically made to hold tapes.
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
