Electronics Forum | Tue Feb 13 13:49:57 EST 2007 | coop
I am talking about an internal tray holder It holds two trays. the lingo doesn't really matter because if you say Internal tray feeder/holder the guys at philips will know exactly what you're talking about. I checked several refurb places and the onl
Electronics Forum | Fri Dec 17 09:05:55 EST 2004 | adlsmt
Has anyone designed a Topaz matrix tray holder? We only need something to hold 4 trays and the Assembleon system is expensive and marginal. We can do it here but if someone else has done it would be happy to share the engineering costs to get some dr
Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester
Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co
Electronics Forum | Thu Oct 29 10:29:13 EDT 2009 | soporto77
Hi, I'd like to know where i can find a Matrix Tray holder cheap (Pick and Place Samsung CP45 Neo) Thank you for your help
Electronics Forum | Wed Dec 30 14:51:50 EST 2009 | gantry
Craig - It has been quite a while but from what I remember you teach the tray holder in teach table top. Then you have to put the part/tray on the the tray holder. Also, ensure the part is in your program. I don't remember where to do that but I
Electronics Forum | Wed May 09 11:13:58 EDT 2001 | davef
Hold it!!! Call Bob over at Tri-Metal Fabricators and ask him to make you one for about 10% of the price a fine OEM would charge. Might not a a fancy anodized finish, but at the end of the day, it'll hold yer trays just fine.
Electronics Forum | Wed Dec 21 08:30:13 EST 2005 | jax
"aj" you should find your way to a training class. The measurement is from the zero point of the tray feeder( almost always the feeder slot pin giude that the center guide of the tray holder hits...located in the machine ). It is not the same as nest
Electronics Forum | Mon May 14 15:20:35 EDT 2001 | stefwitt
You can make up a plate over lapping the tape exit guide and to the right up to the nozzle changer. It should hold three standard size Jedec trays. I used the bases of two old vibratory feeder. No matter what you do, you should use strong magnets to
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
Electronics Forum | Tue May 08 08:26:15 EDT 2001 | caldon
Yes Siemens has a fixed tray feeder for matrix trays. If I remember correctly the tray will occupy 1/2 of the table.The feeder is a two part system 1) is the base 2) the the flat tray (just like what is used in the waffle pack changer). the flat tray
