Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Wed May 12 23:33:04 EDT 1999 | Matt
WARNING: This is a plug. I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" Well I have written w95/database code that reads FUJI output files (CPII,CPII,IP2 etc) and d
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Thu May 13 00:34:49 EDT 1999 | Jeff Sanchez
| WARNING: This is a plug. | | I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" | | Well I have written w95/database code that reads FUJI output files (CPII,CPII,IP2
Electronics Forum | Thu May 13 09:41:25 EDT 1999 | Chrys Shea
| | WARNING: This is a plug. | | | | I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" | | | | Well I have written w95/database code that reads FUJI output files (CPII
Electronics Forum | Thu May 13 21:22:27 EDT 1999 | Matt
| | | WARNING: This is a plug. | | | | | | I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" | | | | | | Well I have written w95/database code that reads FUJI output f
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Tue Nov 15 12:24:12 EST 2011 | nevercry14
Well try to run in idle n as soon as the mtu. Goes to pick up part on tray it goes down but when homing back in position doesnt flag sensor because position is off.so the sz sensor not bieng flaged. Any ideas
Electronics Forum | Fri Mar 22 13:32:15 EDT 2019 | kahrpr
all the motors on the head are the same just the connecting cable are different length. the motors have a home position for the zero pulse that home position has to match when the flag passes through the homing sensor all servos have a home position
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
.gif)
