Electronics Forum | Tue Jul 26 09:48:44 EDT 2016 | leeg
Have you taught the tray position in correctly, I dont know that particular machine but you normally teach in 3 positions. When you have done this have you re-optimised?
Electronics Forum | Sat Feb 16 11:36:09 EST 2019 | robertorocco
When the camera moves to the bord stop position, or to the fiducial position, the following message appears "Axis camera error - out of time" some indication on how to solve the problem? Thanks
Electronics Forum | Mon Feb 25 11:35:40 EST 2019 | dekhead
Does camera complete moves (Baord stop, Fiducial Positions) without error in camera diagnostic?
Electronics Forum | Fri Sep 16 14:12:23 EDT 2011 | jtownsend
Anyone have experience or advice to help prevent SMT reed switches from being blow out of position during re-flow? We are using a Heller 1707 MK 3. Is it possible to adjust air flow in the oven or do we need to glue before placement??
Electronics Forum | Tue Aug 03 17:45:43 EDT 2010 | swag
I used to wrench on those all the time! I really should be more help to you but it was a few years ago... A few more things to check - clean the line sensors on the back of the machine. Check to make sure you don't have a feeder that is allowing t
Electronics Forum | Wed Aug 04 08:40:37 EDT 2010 | keiths487
I used to wrench on those all the time! I really > should be more help to you but it was a few years > ago... A few more things to check - clean the > line sensors on the back of the machine. Check > to make sure you don't have a feeder that i
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con
Electronics Forum | Mon Jul 25 17:27:45 EDT 2016 | victoriajon
Up and running smoothly this morning, but got the attached error when switching from a reel feeder to a tray of the same part. We are getting this error message during setup - any suggestions are welcome. I am available to answer any questions that
Electronics Forum | Tue Oct 05 14:28:26 EDT 2004 | caldon
Hello all- Just an FYI... I have taken a position causing me to leave the SMT/Electronics Manufacturing Industry. I will still be in Technology but geared more towards the service industry. Thanks for everyones help and enjoy... Cal cal_Driscoll@ho
Electronics Forum | Tue Oct 12 10:33:33 EDT 2004 | caldon
I have been in manufacturing for 16+ years and just got tired of grazing for jobs.My last position the manufacturing went to Asia. I was proud to say I was still in SMT through 1999-2004 with the down turn. I wanted something new and different...
