Electronics Forum | Thu Aug 30 14:14:27 EDT 2001 | dougt
James Take a board with double sided tape and run it with all the other parts "shorted". Make sure that the part is being placed by the head/spindle that will be used during a full run. Inspect the part after it is placed and carefully remove it a
Electronics Forum | Sat May 29 15:55:04 EDT 1999 | M Cox
| Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a F
Electronics Forum | Sun Aug 14 22:58:17 EDT 2005 | crishan
Hi All, I would like help in establishing what is a feasible PPM reject rate from a typical SMD line. As a reference an SMD line consists of, solder paste printer, chip component placement, pick and place IC components and reflow. What is a bench
Electronics Forum | Sat May 29 22:20:56 EDT 1999 | Earl Moon
| | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a
Electronics Forum | Fri Nov 04 11:29:46 EST 2005 | JeffP
Jay, I work for a company that manufactures batch reflow ovens however, I will try to be as subjective as possible. For the most part, what others have posted is true. Yes, there is one heating chamber and if the heater does not have enough power
Electronics Forum | Sun May 30 11:43:23 EDT 1999 | M Cox
| | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to
Electronics Forum | Fri Nov 02 11:23:52 EST 2001 | dougt
Here's my 2 cents....... I worked for a small company that manufactures pick and place machines and had the task of testing/troubleshooting and the dreaded calibration. These machines used vision for part orentation and have what I considered aweso
Electronics Forum | Sun May 30 12:33:36 EDT 1999 | Earl Moon
| | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according
Electronics Forum | Sun May 30 15:11:10 EDT 1999 | M Cox
| | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accordin
Electronics Forum | Tue Jul 23 12:02:17 EDT 2002 | gdstanton
Ken, Excellent discussion!!! I've also seen this problem. Spent and am still spending significant time policing. I don't think it is just a buyer issue though. There are many dimensions to the problem. Suppliers, Engineering, Manufacturing, and
