Electronics Forum | Mon Feb 01 08:04:37 EST 2010 | richc7799
Does anyone have available the original specifications for the Siemens F3 with tray unit.
Electronics Forum | Tue May 08 08:26:15 EDT 2001 | caldon
Yes Siemens has a fixed tray feeder for matrix trays. If I remember correctly the tray will occupy 1/2 of the table.The feeder is a two part system 1) is the base 2) the the flat tray (just like what is used in the waffle pack changer). the flat tray
Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester
Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
Electronics Forum | Mon Aug 27 09:56:00 EDT 2001 | stefan
I wonder what kind of equipment the board designer had in mind? Are you shure you can do the board with a Mydata ? Where do you put the tray for your 20 mil QFP's? 10 mm thick plus component height also appears to be a problem. Multitroniks can do la
Electronics Forum | Tue May 06 10:14:18 EDT 2003 | k_h
A typical machine will have around 100 feeder slots. Manufacturers use the slots differently though, use 8mm feeder counts as your basis. Siemens, for example has 40 slots but you can get 2 (or 3) 8mm's per slot giving you 80+ 8mm feeders, while a Sa
Electronics Forum | Wed Aug 13 05:18:40 EDT 2008 | lococost
that's a pretty cool idea, I like some thinking 'outside the box '! 1. I don't think picking it up and placing it will be much of a problem. once the rivet is placed it will be held in place by the paste. However, you would need to make a tray that
Electronics Forum | Wed Jan 09 14:05:58 EST 2008 | edmneb
We recently acquired a Siemens Siplace F3 and a S15 machine, and I am having a few problems with the machines. We have always been a Universal shop, so I am not really familiar with the Siplace machines, and need some help from all of you folks out
Electronics Forum | Sun Jan 16 05:22:36 EST 2005 | dorklover664
I�ve worked as an SMT operator for 3 different companies. And have worked with six different types of pick and place machines. I can tell you what I know. The first place I worked at was high volume low mix and we ran Fuji�s. They are by far the best
Electronics Forum | Fri Jul 24 16:02:13 EDT 1998 | Justin Medernach
200 boards/Hr and oven will reflow ~180 boards/Hr but the P&P machine will only place 700-950 CPH | | | when setup is taken into account. Minimum pitch is normally .020" and we place an Avg. of 491 TSSOPs and 217 BGAs a month. | | | We don't even bo
