Electronics Forum | Thu Dec 16 17:11:51 EST 2004 | jdengler
Clayton On the tray tower, the tray that's at the pick-up level flags a sensor at the back of the tray right next to the lead screw. This sensor needs to be made to zero the machine. Either the trays are out of position or the sensor is bad. Jerr
Electronics Forum | Tue Dec 12 17:45:48 EST 2017 | mac5
We have, in the past, made our own trays for loose parts and put them in the tray tower. Of course someone has to put the parts into the tray so you may not be saving any labor but the machine placement should be faster. BR, Mac
Electronics Forum | Mon Mar 22 15:49:40 EST 2004 | Frank
You can also do what I was doing before we found the one at Nix. We simply used double-sided tape and taped the carrier tape down on to the floors of the tray tower. Can't get much more 'simpler' than that!!!
Electronics Forum | Mon Mar 14 12:49:28 EDT 2011 | cvoyles
The QP242 is a modular placer. If you have the BS (single head)module with the MTU7 tray unit you can most definitely place this device. If you have the BI units with no tray tower it is doubtful.
Electronics Forum | Tue Oct 18 18:01:58 EDT 2016 | jpenner
Currently we place them using the tray system and need to become more efficient. Any ideas? Tubes? Also we have limited space in our tray tower.
Electronics Forum | Mon Mar 22 00:13:06 EST 2004 | D. Sanders
Alan, Just so you have something to compare with, Fuji also carries a solution for your current issue. It allows them to place tape parts on a fixture that allows you to fit up to 20 different parts in the tray tower. It looks like a std. JEDEC tray
Electronics Forum | Thu Aug 13 11:59:09 EDT 1998 | Joe Herz
Greetings, Has anyone purchased Mydata's new "Smart Tray Exchanger"? I'm specifically looking for users who retrofitted this item to an existing machine that was vision capable. This is the box that has a dual tray tower on the front side of the ma
Electronics Forum | Tue Mar 09 14:56:27 EST 2004 | Alan
I have a need to put many different Tape and Reel parts into trays in order to free up feeder space on my QP3. My question is does anyone know of any resources where I can specify my part dimensions and have tray stock milled out to present these pa
Electronics Forum | Fri May 17 09:41:39 EDT 2002 | pteerink
Save your money. I tried to buy one for a G3 before, had one actually shipped in, and had to return it because it didn't fit the machine. Some other options: 1) buy a tape and reel machine cost you about $10K, but then you have control over
Electronics Forum | Wed Jun 02 16:33:08 EDT 2004 | davem
Fuji is the best, but there are other alternatives besides Quad. If you really want to look at Fuji, take a peek at their XP142E series. With "Vision processing on the fly" and a "Mini Turret Head" with 12 placement nozzles it should fit your needs n
