Electronics Forum | Thu Oct 31 11:54:10 EDT 2013 | ke6zoy
I work in a leaded paste world due to aerospace environmental requirements. There are a few cases where parts are only available from suppliers as RoHS. Can anyone recommend how to process these into a leaded assembly? Is it just reflowing at a hi
Electronics Forum | Tue Feb 25 14:39:20 EST 2014 | nicodj77
Stellar Technical Product, we been ordering from them for almost 6 years. My needs where to be used with connectors or power modules on a tray without pick up area (dots) for pick up Fuji nozzle of 5mm. There is no P/N because is a special order, b
Electronics Forum | Fri Jun 27 13:33:59 EDT 2014 | rgduval
I agree with all other posters...strips on the Y-Wagon have always worked out, rather easily. Some people I've met consider it a benefit to having a MyData. However, I would add that MyData's handle strips in the feeders better than most other pick
Electronics Forum | Mon Jun 30 03:21:38 EDT 2014 | sramos
Thanks Alexei for your advice. I consider mainly high-volume production with tape/reel feeders for most components and tray for big ICs. My ultimate goal is a cost estimation of the production activities. So departing from a parts-list, I need to est
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Wed Dec 09 17:22:09 EST 2015 | tombstonesmt
I couldn't be more pleased with Panasonic. We've upgraded from MPAV's and MSR's to CM602/DT401 and now their NPM platform. NPM's are extremely fast and accurate. Their auto pickup position teach is great especially if you're running any 0402 2mm pit
Electronics Forum | Mon Jul 25 17:27:45 EDT 2016 | victoriajon
Up and running smoothly this morning, but got the attached error when switching from a reel feeder to a tray of the same part. We are getting this error message during setup - any suggestions are welcome. I am available to answer any questions that
Electronics Forum | Sun Oct 08 00:02:58 EDT 2017 | sarason
I see this thread has altered a little from the original question to what the Op was actually getting at which is how do you know it is right? Specifically rotation on the board and how that relates to how it came from the feeder or tray. There is a
Electronics Forum | Wed Dec 20 10:44:31 EST 2017 | bobpan
The z-rod bellows on head 2 and head 3 are slightly bent. The machine will show you this error if the runout is over 6.5 mils. This is usually caused by too much z when picking parts out of a vib or tray feeder. The machine will probably run. I ha
Electronics Forum | Sat Feb 17 04:39:29 EST 2018 | leadthree
I ship mainly TNT. They handle the boxes very careful, because it said so on their website ;-) But seriously, we use quality cartons and I feel safe. We use a divider packing and the modules are rather loose since we use it for a few different modul
