Electronics Forum | Thu Nov 18 15:07:27 EST 2004 | valuems
Hello Boy this sure brings back memories from the years past. Was a field engineer for universal for about 9 years. Worked almost exclusively on the Rad 1 and Rad 2. The first thing that I would do is remove the sequencer head that fires at the sa
Electronics Forum | Thu Nov 18 13:44:50 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:45:20 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:47:25 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:52:51 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel ma
Electronics Forum | Tue Jun 21 11:58:42 EDT 2016 | davef
Apologies for my denseness, and I haven't touched a Treiber in years, that said, isn't there "tensioners" on the machine at each end of the chain?
Electronics Forum | Fri Jun 17 17:33:30 EDT 2016 | winterair
The machine has been giving me trouble as the components are frequently lifted off the board and falling off as it goes through the conveyor. I am trying to remove the conveyor chains hoping to re-balance them. Is there a way to remove them and adjus
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Mar 04 19:03:48 EST 2004 | pdeuel
Have you been re lubing chain after cleaning. Is the chain worn thru from friction on rails. How are carbonized particles removed from inside links after cleaning. What is recomended method for cleaning.
Electronics Forum | Tue Jul 15 09:02:09 EDT 2008 | ehess
Has anyone using these ovens had any problems with the chain (flat) belt slipping? I suggested to the tech we remove a link in the flat chain, and he responded it would make it out of warranty. It's the same type of chain flat belt as most wash and
